enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Per-unit system - Wikipedia

   en.wikipedia.org/wiki/Per-unit_system

   By choosing the base quantities in this manner, the transformer can be effectively removed from the circuit as described above. For example: Take a transformer that is rated at 10 kVA and 240/100 V. The secondary side has an impedance equal to 1∠0° Ω. The base impedance on the secondary side is equal to:

3. Buck–boost transformer - Wikipedia

   en.wikipedia.org/wiki/Buck–boost_transformer

   Buck–boost transformers can be used to power low voltage circuits including control, lighting circuits, or applications that require 12, 16, 24, 32 or 48 volts, consistent with the design's secondaries. The transformer is connected as an isolating transformer and the nameplate kVA rating is the transformer’s capacity. [2]

4. 25 kV AC railway electrification - Wikipedia

   en.wikipedia.org/wiki/25_kV_AC_railway...

   The N700 Shinkansen uses a three-level converter to convert 25 kV single-phase AC to 1,520 V AC (via transformer) to 3 kV DC (via phase-controlled rectifier with thyristor) to a maximum 2,300 V three-phase AC (via a variable voltage, variable frequency inverter using IGBTs with pulse-width modulation) to run the motors.

5. Split-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Split-phase_electric_power

   A transformer supplying a three-wire distribution system has a single-phase input (primary) winding. The output (secondary) winding has a center tap connected to a grounded neutral. As shown in Fig. 1, either end to center has half the voltage of end-to-end. Fig. 2 illustrates the phasor diagram

6. NEMA size - Wikipedia

   en.wikipedia.org/wiki/NEMA_size

   Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Special pages; Pages for logged out editors learn more

7. Distribution transformer - Wikipedia

   en.wikipedia.org/wiki/Distribution_transformer

   Distribution transformers typically have ratings less than 200 kVA, [3] although some national standards allow units up to 5000 kVA to be described as distribution transformers. Since distribution transformers are energized 24 hours a day (even when they don't carry any load), reducing iron losses is vital in their design.