enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   Three different international-standard two-hole punches. A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves).

3. Comb binding - Wikipedia

   en.wikipedia.org/wiki/Comb_binding

   To bind a document, the user first punches holes in the paper with a specialized hole punch. Pages must be punched a few at a time with most of these machines. If hard covers are desired, they must be punched as well. In bulk applications, a paper drilling machine may be used. Then the user chooses a spine size that will match the document.

4. 19-inch rack - Wikipedia

   en.wikipedia.org/wiki/19-inch_rack

   The size denotes the width of the faceplate for the installed equipment. The rack unit is a measure of vertical spacing and is common to both the 19 and 23-inch racks. Hole spacing is either on 1-inch (25 mm) centers (Western Electric standard), or the same as for 19-inch (482.6 mm) racks (0.625 in or 15.9 mm spacing).

5. Ring binder - Wikipedia

   en.wikipedia.org/wiki/Ring_binder

   The most common type in Canada and the United States is a three-ring system for letter size pages (8 + 1 ⁄ 2 by 11 inches or 220 mm × 280 mm), whose size is similar to ISO 216-based A4 size. A standard 8 + 1 ⁄ 2 by 11 inches (220 mm × 280 mm) sheet of paper has three holes with spacing of 4 + 1 ⁄ 4 inches (110 mm).

6. File:Common-hole-patterns-in-punches-and-binders.svg

   en.wikipedia.org/wiki/File:Common-hole-patterns...

   English: Common hole patterns used in ring binders and hole punches, including personal organizers. Polski: Układy otworów w segregatorach i dziurkaczach, z uwzględnieniem najpopularniejszych organizerów

7. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   The two most common are those sized for standard electrical knockout sizes and those that are for true dimensional holes. A 3/4 inch conduit size punch actually punches a hole that is approximately 1.1 inches diameter for 3/4 nominal size conduit. A dimensional size punch makes a hole very close to the indicated size.