Search results
Results from the WOW.Com Content Network
In the design of Dulles airport, the floor, the columns and the roof all work together to allow the walls and ceiling to float. [6] This leaves a large open space for the building. [7] The Yoyogi National Gymnasium in Tokyo is an example of a cable suspended structure. The roof system is a large span and the structure has been called "one of ...
A typical timber shear wall consists of braced panels in the wall line, constructed using structural plywood sheathing, specific nailing at the edges, and supporting framing. A shear wall is an element of a structurally engineered system that is designed to resist in-plane lateral forces, typically wind and seismic loads.
In architecture, a core is a vertical space used for circulation and services. It may also be referred to as a circulation core or service core. A core may include staircases, elevators, electrical cables, water pipes and risers. A core allows people to move between the floors of a building, and distributes services efficiently to the floors.
Core-and-veneer, brick and rubble, wall and rubble, ashlar and rubble, and emplekton all refer to a building technique where two parallel walls are constructed and the core between them is filled with rubble or other infill, creating one thick wall. [1] Originally, and in later poorly constructed walls, the rubble was not consolidated.
Barrier walls are designed to allow water to be absorbed but not penetrate the wall, and include concrete and some masonry walls. Drainage walls allow water that leaks into the wall to drain out such as cavity walls. Drainage walls may also be ventilated to aid drying such as rainscreen and pressure equalization wall systems. Sealed-surface ...
The schematic is a line diagram, not necessarily to scale, that describes interconnection of components in a system. The main features of a schematic drawing show: A two dimensional layout with divisions that show distribution of the system between building levels, or an isometric-style layout that shows distribution of systems across ...
Slurry wall design is undertaken based on bending moment and shear envelope obtained from the stress analysis. In the design of such underground walls, width of the unit is considered as one meter, and the wall is analyzed under plane strain condition. Since the length-to-width ratio of excavations is generally large, plane strain conditions ...
In the past two decades the steel plate shear wall (SPSW), also known as the steel plate wall (SPW), has been used in a number of buildings in Japan and North America as part of the lateral force resisting system. In earlier days, SPSWs were treated like vertically oriented plate girders and design procedures tended to be very conservative.