Ad
related to: miniature engines that run on gas and light and go through fire
Search results
Results from the WOW.Com Content Network
A glow plug engine, or glow engine, is a type of small internal combustion engine [1] typically used in model aircraft, model cars and similar applications. The ignition is accomplished by a combination of heating from compression, heating from a glow plug and the catalytic effect of the platinum within the glow plug on the methanol within the ...
Nitro- and gasoline-powered tether cars with .60 cubic inch miniature engines capable of speeds of 100 mph (160 km/h) were quickly becoming popular. Cox's first contribution to that growing hobby was a cast aluminum midget racer powered by a .09 and .15 engine by Cameron Brothers of Chino, California.
After starting the engine can easily be leaned (by adjusting a needle valve in the spraybar) to obtain maximum power. Glowplug engines are also known as nitro engines. Nitro engines require a 1.5 volt ignitor to light the glow plug in the heat sink. Once primed, pulling the starter with the ignitor in will start the engine.
Some of the engines were intended to do a job of work rather than for the entertainment of a model engineer, for example, the 1935 Sandhurst horizontal 2/3 bhp engine, which was described thus: [18] 'This engine will run on gas or petrol and is designed for continuous work such as dynamo, workshop or pump driving. It is supplied only as ...
In a steam engine, the firebox is the area where the fuel is burned, producing heat to boil the water in the boiler. Most are somewhat box-shaped, hence the name. The hot gases generated in the firebox are pulled through a rack of tubes running through the boiler. [1] [2]
A gunpowder engine, also known as an explosion engine or Huygens' engine, is a type of internal combustion engine using gunpowder as its fuel. The concept was first explored during the 1600s, most notably by famous Dutch polymath Christiaan Huygens .
The engine could drive a three-bladed propeller with a diameter of 1.5 inches (38 mm) through a pulley system, unlike the stern tube setup used by the ME1. Similar to many other marine engines produced by Mamod, the SEL engine used in the ME3 did not incorporate a lubricator and required meticulous adjustment for optimal functioning.
A nitro engine generally refers to an engine powered with a fuel that contains some portion (usually between 10% and 40%) of nitromethane mixed with methanol.Nitromethane is a highly combustible substance that is generally only used in very specifically designed engines found in Top Fuel drag racing and in miniature internal combustion engines in radio control, control line and free flight ...
Ad
related to: miniature engines that run on gas and light and go through fire