enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. DMX512 - Wikipedia

   en.wikipedia.org/wiki/DMX512

   Typically a dimmer has a starting address that represents the lowest-numbered dimmer in that pack, and the addressing increases from there to the highest-numbered dimmer. As an example, for two packs of six dimmers each, the first pack would start at address 1 and the second pack at address 7. Each slot in the DMX512 packet corresponds to one ...

3. 0-10 V lighting control - Wikipedia

   en.wikipedia.org/wiki/0-10_V_lighting_control

   The switch is controlled by a PWM (Pulse Width Modulation) signal, which alternately turns the switch on and off at a rapid rate. The relative proportion of off time vs. on time determines brightness. For example, if the switch is off 10% of the time, the resulting control signal would be the equivalent of 1 V produced with a variable resistor.

4. Dimmer - Wikipedia

   en.wikipedia.org/wiki/Dimmer

   Dimmer in a residential application with RF-based remote control. Non domestic dimmers are usually controlled remotely by means of various protocols. Analogue dimmers usually require a separate wire for each channel of dimming carrying a voltage between 0 and 10 V. Some analogue circuitry then derives a control signal from this and the mains ...

5. RDM (lighting) - Wikipedia

   en.wikipedia.org/wiki/RDM_(lighting)

   Remote Device Management (RDM) is an addition to the DMX512 control protocol for stage lighting equipment, introduced in 2006. DMX512 was developed in the late 1980s as a standard protocol for lighting consoles to communicate with dimmers, but has since been used for more complex applications, including the control of intelligent lighting fixtures.

6. Multiway switching - Wikipedia

   en.wikipedia.org/wiki/Multiway_switching

   In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.

7. Light switch - Wikipedia

   en.wikipedia.org/wiki/Light_switch

   Two light switches in one box. The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1]