enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The major diameter still extends to within ⁠ 1 / 8 ⁠ H of the theoretical sharp V, but the total depth of the thread is reduced 4% from ⁠ 5 / 8 ⁠ H = ⁠ 5 / 8 ⁠ cos(30°) P ≈ 0.541P to 0.52P. [5] This increases the amount of the theoretical sharp V which is cut off at the minor diameter by 10% from 0.25H to ⁠ 7 / 8 ⁠ − ⁠ 0. ...

3. British Association screw threads - Wikipedia

   en.wikipedia.org/wiki/British_Association_screw...

   The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats) is 1.75 times the major diameter. BA sizes are specified by the following British Standards: BS 57:1951 — B.A. screws, bolts and nuts

4. Barrel threads - Wikipedia

   en.wikipedia.org/wiki/Barrel_threads

   7/8"-16 Savage Model 1920 ... The barrel nut threads are M36.51 x 1.588 mm (1-7/16"-16, tolerance class 2A). ... 3.8 mm depth countersink for the bolt head with a 17. ...

5. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   To simplify matters, the term hexagon is used in this section to denote either bolt head or nut. Two spanners, both nominal size 5 ⁄ 8 in, with a diagram superimposed to show the logic that allows them both to be nominal size 5 ⁄ 8 in when their actual sizes are clearly different (across-flats distance vs screw diameter). The across-flats ...

6. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   The minimum limits for external (or bolt, in ISO terminology), and the maximum limits for internal (nut), thread sizes are there to ensure that threads do not strip at the tensile strength limits for the parent material. The minimum limits for internal, and maximum limits for external, threads are there to ensure that the threads fit together.

7. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   Hexagonal (generally abbreviated to "hex") head widths (width across flats, spanner size) are for DIN 934 hex nuts and hex head bolts. Other (usually smaller) sizes may occur to reduce weight or cost, including the small series flange bolts defined in ISO 4162 which typically have hexagonal head sizes corresponding to the smaller 1st choice ...