Search results
Results from the WOW.Com Content Network
This is the only type of static compression that liquids and gases can bear. [3] It affects the volume of the material, as quantified by the bulk modulus and the volumetric strain. The inverse process of compression is called decompression, dilation, or expansion, in which the object enlarges or increases in volume.
As the force in member 1 is towards the joint, the member is under compression, the force in member 4 is away from the joint so the member 4 is under tension. The length of the lines for members 1 and 4 in the diagram, multiplied with the chosen scale factor is the magnitude of the force in members 1 and 4.
The strength of materials is determined using various methods of calculating the stresses and strains in structural members, such as beams, columns, and shafts. The methods employed to predict the response of a structure under loading and its susceptibility to various failure modes takes into account the properties of the materials such as its yield strength, ultimate strength, Young's modulus ...
Tension is the pulling or stretching force transmitted axially along an object such as a string, rope, chain, rod, truss member, or other object, so as to stretch or pull apart the object. In terms of force, it is the opposite of compression. Tension might also be described as the action-reaction pair of forces acting at each end of an object.
In mechanics, compressive strength (or compression strength) is the capacity of a material or structure to withstand loads tending to reduce size (compression). It is opposed to tensile strength which withstands loads tending to elongate, resisting tension (being pulled apart).
In statics all forces and moments must balance to zero; the physical interpretation is that if they do not, the body is accelerating and the principles of statics do not apply. In dynamics the resultant forces and moments can be non-zero. Free body diagrams may not represent an entire physical body. Portions of a body can be selected for analysis.
The vector T may be regarded as the sum of two components: the normal stress (compression or tension) perpendicular to the surface, and the shear stress that is parallel to the surface. If the normal unit vector n of the surface (pointing from Q towards P ) is assumed fixed, the normal component can be expressed by a single number, the dot ...
Dead loads are static forces that are relatively constant for an extended time. They can be in tension or compression. The term can refer to a laboratory test method or to the normal usage of a material or structure. Live loads are usually variable or moving loads.