Search results
Results from the WOW.Com Content Network
The inlet pressure gauge will indicate this pressure. The gas then passes through the normally open pressure control valve orifice and the downstream pressure rises until the valve actuating diaphragm is deflected sufficiently to close the valve, preventing any more gas from entering the low pressure side until the pressure drops again.
All mass flow controllers have an inlet port, an outlet port, a mass flow sensor and a proportional control valve. The MFC is fitted with a closed loop control system which is given an input signal by the operator (or an external circuit/computer) that it compares to the value from the mass flow sensor and adjusts the proportional valve ...
Proportional control, in engineering and process control, is a type of linear feedback control system in which a correction is applied to the controlled variable, and the size of the correction is proportional to the difference between the desired value (setpoint, SP) and the measured value (process variable, PV).
A proportioning valve is a valve that relies on the laws of fluid pressure to distribute input forces to one or more output lines. Proportioning valves are frequently used in cars and other road vehicles to reduce the brake fluid pressure to the rear brakes. Due to weight distribution during heavy braking, more pressure is needed for front brakes.
A pressure force due controlled flow areas and supply pressure, often called line pressure; The VFS can be designed such that any of these forces act in either axial direction. If the magnetic force acts opposes the pressure force, then increasing current through the solenoid coil will, at steady-state, cause an increase in VFS output pressure.
The hydraulic actuators respond to changes of pressure or flow and will open or close the valve. Automatic control valves do not require an external power source, meaning that the fluid pressure is enough to open and close them. Flow control valves, a type of automatic control valve, regulate fluid flow by maintaining a predetermined flow rate ...
Simple hydraulic control valves are binary, they are either on or off. Servo valves are different in that they can continuously vary the flow they supply from zero up to their rated maximum flow, or until the output pressure reaches the supplied pressure. More complex servo valves can control other parameters.
Needle valve for accurate flow control; Pinch valve, for slurry flow regulation and control; Piston valve, for regulating fluids that carry solids in suspension; Piston valve (steam engine) Plug valve, slim valve for on–off control but with some pressure drop; Solenoid valve, an electrically actuated valve for hydraulic or pneumatic fluid control