Search results
Results from the WOW.Com Content Network
When a program wants to time its own operation, it can use a function like the POSIX clock() function, which returns the CPU time used by the program. POSIX allows this clock to start at an arbitrary value, so to measure elapsed time, a program calls clock(), does some work, then calls clock() again. [1] The difference is the time needed to do ...
While early generations of CPUs carried out all the steps to execute an instruction sequentially, modern CPUs can do many things in parallel. As it is impossible to just keep doubling the speed of the clock, instruction pipelining and superscalar processor design have evolved so CPUs can use a variety of execution units in parallel - looking ahead through the incoming instructions in order to ...
To get better CPI values without pipelining, the number of execution units must be greater than the number of stages. For example, with six executions units, six new instructions are fetched in stage 1 only after the six previous instructions finish at stage 5, therefore on average the number of clock cycles it takes to execute an instruction ...
Instructions per second (IPS) is a measure of a computer's processor speed. For complex instruction set computers (CISCs), different instructions take different amounts of time, so the value measured depends on the instruction mix; even for comparing processors in the same family the IPS measurement can be problematic.
If we ignore both these effects, then the average memory access time becomes an important metric. It provides a measure of the performance of the memory systems and hierarchies. It refers to the average time it takes to perform a memory access. It is the addition of the execution time for the memory instructions and the memory stall cycles.
Profilers interrupt program execution to collect information, which may result in a limited resolution in the time measurements, which should be taken with a grain of salt. Basic block profilers report a number of machine clock cycles devoted to executing each line of code, or a timing based on adding these together; the timings reported per ...
The C date and time functions are a group of functions in the standard library of the C programming language implementing date and time manipulation operations. [1] They provide support for time acquisition, conversion between date formats, and formatted output to strings.
Further, a "cumulative clock rate" measure is sometimes assumed by taking the total cores and multiplying by the total clock rate (e.g. a dual-core 2.8 GHz processor running at a cumulative 5.6 GHz). There are many other factors to consider when comparing the performance of CPUs, like the width of the CPU's data bus , the latency of the memory ...