Search results
Results from the WOW.Com Content Network
This process took a total of 0.02 seconds of CPU time (User + System). The reported System time is 0.00 seconds, indicating that the amount of System time used was less than the printed resolution of 0.01 seconds. Elapsed real time was 0.08 seconds. The following is the source code of the application nextPrimeNumber which was used in the above ...
While early generations of CPUs carried out all the steps to execute an instruction sequentially, modern CPUs can do many things in parallel. As it is impossible to just keep doubling the speed of the clock, instruction pipelining and superscalar processor design have evolved so CPUs can use a variety of execution units in parallel - looking ahead through the incoming instructions in order to ...
To get better CPI values with pipelining, there must be at least two execution units. For example, with two executions units, two new instructions are fetched every clock cycle by exploiting instruction-level parallelism, therefore two different instructions would complete stage 5 in every clock cycle and on average the number of clock cycles ...
Instructions per second (IPS) is a measure of a computer's processor speed. For complex instruction set computers (CISCs), different instructions take different amounts of time, so the value measured depends on the instruction mix; even for comparing processors in the same family the IPS measurement can be problematic.
computes the difference in seconds between two time_t values time: returns the current time of the system as a time_t value, number of seconds, (which is usually time since an epoch, typically the Unix epoch). The value of the epoch is operating system dependent; 1900 and 1970 are often used. See RFC 868. clock
The resolution of an implementation's measurement of time does not imply the same precision of such measurements. For example, a system might return the current time as a value measured in microseconds, but actually be capable of discerning individual clock ticks with a frequency of only 100 Hz (10 ms).
Further, a "cumulative clock rate" measure is sometimes assumed by taking the total cores and multiplying by the total clock rate (e.g. a dual-core 2.8 GHz processor running at a cumulative 5.6 GHz). There are many other factors to consider when comparing the performance of CPUs, like the width of the CPU's data bus , the latency of the memory ...
Software timekeeping systems vary widely in the resolution of time measurement; some systems may use time units as large as a day, while others may use nanoseconds.For example, for an epoch date of midnight UTC (00:00) on 1 January 1900, and a time unit of a second, the time of the midnight (24:00) between 1 January 1900 and 2 January 1900 is represented by the number 86400, the number of ...