Search results
Results from the WOW.Com Content Network
The LLC header includes two eight-bit address fields, called service access points (SAPs) in OSI terminology; when both source and destination SAP are set to the value 0xAA, the LLC header is followed by a SNAP header. The SNAP header allows EtherType values to be used with all IEEE 802 protocols, as well as supporting private protocol ID spaces.
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header. It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header. Both fields are eight bits wide.
Segment terminator indicates the end of a message segment. Note: The line breaks after each segment in this example have been added for readability. There are typically no line breaks in EDI data. UNH +1+PAORES: 93: 1: IA ' - This is the message header segment which is required at the start of every message. This code specifies that the message ...
The SAP is a conceptual location at which one OSI layer can request the services of another OSI layer. As an example, PD-SAP or PLME-SAP in IEEE 802.15.4 can be mentioned, where the medium access control (MAC) layer requests certain services from the physical layer .
SMB Server Message Block; SMPP Short Message Peer-to-Peer; SOCKS "SOCKetS" ZIP Zone Information Protocol {For AppleTalk} This layer provides session management capabilities between hosts. For example, if some host needs a password verification for access and if credentials are provided then for that session password verification does not happen ...
The amount of data in a data segment must be small enough to allow for a network-layer header and a transport-layer header. For example, for data being transferred across Ethernet, the MTU is 1500 bytes, the minimum size of a TCP header is 20 bytes, and the minimum size of an IPv4 header is 20 bytes, so the maximum segment size is 1500−(20+20 ...
In HTTP version 1.x, header fields are transmitted after the request line (in case of a request HTTP message) or the response line (in case of a response HTTP message), which is the first line of a message. Header fields are colon-separated key-value pairs in clear-text string format, terminated by a carriage return (CR) and line feed (LF ...
ISO 15765-2, [1] or ISO-TP (Transport Layer), is an international standard for sending data packets over a CAN-Bus. The protocol allows for the transport of messages that exceed the eight byte maximum payload of CAN frames. ISO-TP segments longer messages into multiple frames, adding metadata (CAN-TP Header) that allows the interpretation of ...