Search results
Results from the WOW.Com Content Network
Hydraulic head or piezometric head is a measurement related to liquid pressure (normalized by specific weight) and the liquid elevation above a vertical datum. [ 1 ] [ 2 ] It is usually measured as an equivalent liquid surface elevation, expressed in units of length, at the entrance (or bottom) of a piezometer .
Pressure head is a component of hydraulic head, in which it is combined with elevation head. When considering dynamic (flowing) systems, there is a third term needed: velocity head. Thus, the three terms of velocity head, elevation head, and pressure head appear in the head equation derived from the Bernoulli equation for incompressible fluids:
h = z + p / ρg is the piezometric head or hydraulic head (the sum of the elevation z and the pressure head) [11] [12] and; p 0 = p + q is the stagnation pressure (the sum of the static pressure p and dynamic pressure q). [13] The constant in the Bernoulli equation can be normalized.
Hydraulic head (or piezometric head) is a specific measurement of the potential of water above a vertical datum. [7] It is the height of the free surface of water above a given point beneath the surface. [4] Pumping level is the level of water in the well during pumping. [8] Specific capacity is the well yield per unit of drawdown. [8]
where q is the volume flux vector of the fluid at a particular point in the medium, h is the total hydraulic head, and K is the hydraulic conductivity tensor, at that point. The hydraulic conductivity can often be approximated as a scalar. (Note the analogy to Ohm's law in electrostatics. The flux vector is analogous to the current density ...
In fluid dynamics, total dynamic head (TDH) is the work to be done by a pump, per unit weight, per unit volume of fluid. TDH is the total amount of system pressure, measured in feet, where water can flow through a system before gravity takes over, and is essential for pump specification.
Euler’s pump and turbine equations can be used to predict the effect that changing the impeller geometry has on the head. Qualitative estimations can be made from the impeller geometry about the performance of the turbine/pump. This equation can be written as rothalpy invariance: =
Hydraulic head is a directly measurable property that can take on any value (because of the arbitrary datum involved in the z term); ψ can be measured with a pressure transducer (this value can be negative, e.g., suction, but is positive in saturated aquifers), and z can be measured relative to a surveyed datum (typically the top of the well ...