Search results
Results from the WOW.Com Content Network
In this circuit the emitter terminal of the transistor serves as the input, the collector as the output, and the base is connected to ground, or "common", hence its name. The analogous field-effect transistor circuit is the common-gate amplifier.
Figure 1: Basic NPN common collector circuit (neglecting biasing details).. In electronics, a common collector amplifier (also known as an emitter follower) is one of three basic single-stage bipolar junction transistor (BJT) amplifier topologies, typically used as a voltage buffer.
In field-effect transistors (FETs), depletion mode and enhancement mode are two major transistor types, corresponding to whether the transistor is in an on state or an off state at zero gate–source voltage. Enhancement-mode MOSFETs (metal–oxide–semiconductor FETs) are the common switching elements in most integrated circuits.
The MOSFET is by far the most widely used transistor for both digital circuits as well as analog circuits, [104] accounting for 99.9% of all transistors in the world. [102] The bipolar junction transistor (BJT) was previously the most commonly used transistor during the 1950s to 1960s.
The PMOS transistor's channel is in a low resistance state, connecting Vdd to Q. Q, therefore, registers Vdd. On the other hand, when the voltage of A is high (i.e. close to Vdd), the PMOS transistor is in a high resistance state, disconnecting Vdd from Q. The NMOS transistor is in a low resistance state, connecting Vss to Q. Now, Q registers Vss.
The intersections of the load line with the transistor characteristic curves represent the circuit-constrained values of I C and V CE at different base currents. [2] If the transistor could pass all the current available, with no voltage dropped across it, the collector current would be the supply voltage V CC over R L. This is the point where ...
It is applicable to electronic circuits in which the AC signals (i.e., the time-varying currents and voltages in the circuit) are small relative to the DC bias currents and voltages. A small-signal model is an AC equivalent circuit in which the nonlinear circuit elements are replaced by linear elements whose values are given by the first-order ...
Figure 1: Basic N-channel JFET common-source circuit (neglecting biasing details). Figure 2: Basic N-channel JFET common-source circuit with source degeneration. In electronics, a common-source amplifier is one of three basic single-stage field-effect transistor (FET) amplifier topologies, typically used as a voltage or transconductance amplifier.