Search results
Results from the WOW.Com Content Network
TE buffer is also known as T 10 E 1 buffer, which can be read as "T ten E one buffer". To make a 100 ml solution of T 10 E 1 buffer, 1 ml of 1 M Tris base (pH 10–11) and 0.2 ml EDTA (0.5 M) are mixed and made up with double distilled water up to 100ml. Add microliter amounts of high molarity HCl to lower the pH to 8.
TAE buffer is commonly prepared as a 50× stock solution for laboratory use. A 50× stock solution can be prepared by dissolving 242 g Tris base in water, adding 57.1 ml glacial acetic acid, and 100 ml of 500 mM EDTA (pH 8.0) solution, and bringing the final volume up to 1 litre.
TBE or Tris/Borate/EDTA, is a buffer solution containing a mixture of Tris base, boric acid and EDTA.. In molecular biology, TBE and TAE buffers are often used in procedures involving nucleic acids, the most common being electrophoresis.
Phenol: The phenol used for biochemistry comes as a water-saturated solution with Tris buffer, as a Tris-buffered 50% phenol, 50% chloroform solution, or as a Tris-buffered 50% phenol, 48% chloroform, 2% isoamyl alcohol solution (sometimes called "25:24:1"). Phenol is naturally somewhat water-soluble, and gives a fuzzy interface, which is ...
A buffer solution is a solution where the pH does not change significantly on dilution or if an acid or base is added at constant temperature. [1] Its pH changes very little when a small amount of strong acid or base is added to it. Buffer solutions are used as a means of keeping pH at a nearly constant value in a wide variety of chemical ...
The following is a sample recipe for TBST: 20 mM Tris; 150 mM NaCl; 0.1% Tween 20; Adjust pH with HCl to pH 7.4–7.6 The simplest way to prepare a TBS-Tween solution is to use TBS-T tablets. They are formulated to give a ready to use TBST solution upon dissolution in 500 ml of deionized water. [1]
At a given voltage, heat will be generated and thus the gel will be heated. However, SB buffer has lower conductivity than TBE and TAE, and thus the gel temperature is much lower than with TBE or TAE buffers. Therefore, the voltage can be increased to speed up electrophoresis so that a gel run takes only a fraction of the usual time.
Ringer's solution is a solution of several salts dissolved in water for the purpose of creating an isotonic solution relative to the body fluids of an animal. Ringer's solution typically contains sodium chloride , potassium chloride , calcium chloride and sodium bicarbonate , with the last used to buffer the pH .