Search results
Results from the WOW.Com Content Network
A wire-cut EDM machine using the CNC drawing plotter and optical line follower techniques was produced in 1974. Dulebohn later used the same plotter CNC program to directly control the EDM machine, and the first CNC EDM machine was produced in 1976. [10] Commercial wire EDM capability and use has advanced substantially during recent decades. [11]
Electrical discharge machining (or EDM) is one of the most accurate manufacturing processes available for creating complex or simple shapes and geometries within parts and assemblies. A machining method typically used for hard metals, EDM makes it possible to work with metals for which traditional machining techniques are ineffective. [1]
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
This is an accepted version of this page This is the latest accepted revision, reviewed on 28 January 2025. Manufacturing processes This section does not cite any sources.
Machining is a form of subtractive manufacturing, [1] which utilizes machine tools, in contrast to additive manufacturing (e.g. 3D printing), which uses controlled addition of material. Machining is a major process of the manufacture of many metal products, but it can also be used on other materials such as wood, plastic, ceramic, and ...
The grinding operation is combined with EDM for several reasons. For example, according to Modern Machine Shop, [citation needed] the combination allows a higher material removal rate and is therefore more cost effective. Also, the EDM process slightly affects the surface finish. Grinding is used on the affected area to provide a finer final ...
For example, it may take only 2 minutes to machine the face of a small part, but it will take an hour to set the machine up to do it. Or, if there are 5 operations at 1.5 hours each, but only 30 minutes total machine time, then 7.5 hours is charged for just 30 minutes of machining. [3]
Electrochemical machining, as a technological method, originated from the process of electrolytic polishing offered already in 1911 by a Russian chemist E. Shpitalsky. [3] As far back as 1929, an experimental ECM process was developed by W.Gussef, although it was 1959 before a commercial process was established by the Anocut Engineering Company.