Search results
Results from the WOW.Com Content Network
4.5 + 4.5: H: 91.3 L: 65.1 W: 52.4 This battery contained two independent 4.5 V batteries, and had a four-pin connector. 9 V with a center tap was available by wiring in series. There were two ⌀3.2 mm negative pins spaced 9.5 mm apart and two ⌀4.0 mm positive pins spaced 14.3 mm apart. Negative and positive pins were spaced 18.1 mm apart.
H 2 SO 4: Lead dioxide: Yes 1881 [1] 1.75 [2] 2.1 [2] 2.23–2.32 [2] 0.11–0.14 (30–40) [2] 0.22–0.27 (60–75) [2] 180 [2] 5.44–13.99 (72–184) [2] 50–92 [2] 3–20 [2] Zinc–carbon: Carbon–zinc Zinc: NH 4 Cl Manganese (IV) oxide: No 1898 [3] 0.75–0.9 [3] 1.5 [3] 0.13 (36) [3] 0.33 (92) [3] 10–27 [3] 2.49 (402) [3] 50–60 [3 ...
Speer Gold Dot 124gr 9mm+P in SIG P226 magazines. Overpressure ammunition, commonly designated as +P or +P+ (pronounced Plus-P or Plus-P-Plus), is small arms ammunition that has been loaded to produce a higher internal pressure when fired than is standard for ammunition of its caliber (see internal ballistics), but less than the pressures generated by a proof round.
The older .38 ACP cartridge propels a 130-grain (8.4 g) bullet at 1,050 ft/s (320.0 m/s), whereas the .38 Super pushes the same bullet at 1,280 ft/s (390.1 m/s). [3] The .38 Super has gained distinction as the caliber of choice for many top practical shooting competitors; it remains one of the dominant calibers in IPSC competition.
9mm Major is a wildcat cartridge of the 9mm Luger specifically for competition pistols designed to handle very high pressure. It is used in practical shooting competitions like International Practical Shooting Confederation (IPSC) and United States Practical Shooting Association (USPSA) to achieve a "Major" power factor, which earns more points for hits in specific zones on paper targets ...
Visually, it resembles a .38 S&W but the case dimensions are slightly different. The .38 Short Colt case is the parent to the .38 Long Colt and .38 Special.. Remington is one of the few producers of this cartridge today with a 125 gr LRN bullet.
The round was derived from the 14.5×114mm round by necking it out to 23 mm. [1] The original rounds used a lower power charge of 33 g of sw 4/7 powder and achieved 690 m/s at a maximum pressure of 294.3 MPa. In 1954 an improved ammunition was introduced, featuring better projectile design and ballistic properties.
Gas checks are most commonly found in the form of a thin cup or disc made of a ductile metal. Copper, zinc, aluminum, and alloys such as brass have been used. A bullet designed to accept a gas check has a rebated base shank which permits attachment of the check without altering the maximum diameter of the bullet.