Search results
Results from the WOW.Com Content Network
PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM). Conversely the power supply is turned off when the PS ...
The connector was formally adopted as part of PCI Express 5. [1] The connector was replaced by a minor revision called 12V-2x6 (H++), introduced in 2023, [2] [3] which changed the GPU- and PSU-side connectors to ensure that the sense pins only make contact if the power pins are seated properly. The cables and their connectors remained unchanged.
IC power-supply pins are voltage and current supply terminals found on integrated circuits (ICs) in electrical engineering, electronic engineering, and integrated circuit design. [ a ] ICs have at least two pins that connect to the power rails of the circuit in which they are installed.
A power supply with a 24-pin connector can be used on a motherboard with a 20-pin connector. In cases where the motherboard has a 24-pin connector, some power supplies come with two connectors (one with 20-pin and other with 4-pin, i.e. 20+4-pin form) which can be used together to form the 24-pin connector.
The Cisco Supervisor Engine serves as the management card for modular Cisco switches that can also, in some cases, act as forwarding/routing element. [1]Over time, the Supervisor Engine has undergone multiple iterations and was different for different modular switches in Cisco Portfolio (Catalyst 4000, 4500, 5000, 5500, 6000, 6500, 9400, 9600 and Nexus switches).
Power On (IEC 60417-5007) and Power Off (IEC 60417-5008) symbols are used to indicate positions of the rocker switch Power button marked with Standby symbol (IEC 60417-5009) turns the device on or off without fully disconnecting power supply. A power symbol is a symbol indicating that a control activates or deactivates a particular device.
SCSI hard drives showing 80-pin SCA connector (top), and separate 68-pin and power connectors plus configuration jumpers (bottom) SCSI backplane with 80-pin SCA connectors. Hard Drives are mounted on proprietary hot-swappable caddies. Single Connector Attachment, or SCA, is a type of connection for the internal cabling of Parallel SCSI systems ...
Blade connector, commonly found in cars for quick connection of wiring to electrical components; IEC 60309 (BS 4343), so-called "Commando" plug and socket; IEC 60320, connectors for power supply cords to electrical appliances; Molex connector, four-pin hard disk drive (HDD) connectors, also used for powering CD-ROM drives, burners etc.