Search results
Results from the WOW.Com Content Network
A 1:1 scale construction drawing of a boat and its parts Lines plan A scaled-down version of a full-sized drawing often including the body, plan, profile, and section views Body Plan A view of the boat from both dead ahead and dead astern split in half Plan view A view looking down on the boat from above Profile view A view of the boat from the ...
Type G lines are used for centre lines. These are dotted lines, but a long line of 10–20 mm, then a 1 mm gap, then a small line of 2 mm. 2H pencil; Type H lines are the same as type G, except that every second long line is thicker. These indicate the cutting plane of an object. 2H pencil
Normally the largest paper size used in modern architectural practice is ISO A0 (841 mm × 1,189 mm or 33.1 in × 46.8 in) or in the USA Arch E (762 mm × 1,067 mm or 30 in × 42 in) or Large E size (915 mm × 1,220 mm or 36 in × 48 in). [3] Architectural drawings are drawn to scale so that relative sizes are correctly represented.
A cutaway drawing is a technical illustration, in which part of the surface of a three-dimensional model is removed in order to show some of the model's interior in relation to its exterior. The purpose of a cutaway drawing is to "allow the viewer to have a look into an otherwise solid opaque object.
The triple sheet method is an approach to bed making that employs three sheets instead of the traditional two. It also includes a duvet insert or a lightweight comforter, but eliminates the need ...
The instrument is named after its resemblance to the letter T, with a long shaft called the "blade" and a short shaft called the "stock" or "head". T-squares are available in a range of sizes, with common lengths being 18 inches (460 mm), 24 inches (610 mm), 30 inches (760 mm), 36 inches (910 mm) and 42 inches (1,100 mm).
ISO 5456 Technical drawings — Projection methods. ISO 5456-1:1996 Technical drawings — Projection methods — Part 1: Synopsis; ISO 5456-2:1996 Technical drawings — Projection methods — Part 2: Orthographic representations; ISO 5456-3:1996 Technical drawings — Projection methods — Part 3: Axonometric representations
It is also called a plan which is a measured plane typically projected at the floor height of 4 ft (1.2 m), as opposed to an elevation which is a measured plane projected from the side of a building, along its height, or a section or cross section where a building is cut along an axis to reveal the interior structure.