enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Street elbow - Wikipedia

   en.wikipedia.org/wiki/Street_elbow

   Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   An elbow is installed between two lengths of pipe (or tubing) to allow a change of direction, usually a 90° or 45° angle; 22.5° elbows are also available. The ends may be machined for butt welding, threaded (usually female), or socketed. When the ends differ in size, it is known as a reducing (or reducer) elbow.

4. Nipple (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Nipple_(plumbing)

   The length of the nipple is usually specified by the overall length with thread. It may have a hexagonal section in the center for a wrench to grasp (sometimes referred to as a "hex nipple"), or it may simply be made from a short piece of pipe (sometimes referred to as a "barrel nipple" or "pipe nipple").

5. List of unusual units of measurement - Wikipedia

   en.wikipedia.org/wiki/List_of_unusual_units_of...

   A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...

6. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′. The standard for Nominal Pipe Size (often abbreviated NPS, which should not be confused with the abbreviation NPS for the straight thread form standard) is loosely related to the inside diameter of Schedule 40 series of sizes.

7. Ell - Wikipedia

   en.wikipedia.org/wiki/Ell

   The word literally means "arm", and survives in the modern English word "elbow" (arm-bend). Later usage through the 19th century refers to several longer units, [2] [3] some of which are thought to derive from a "double ell". [4] [5] An ell-wand or ellwand was a rod of length one ell used for official measurement.