Search results
Results from the WOW.Com Content Network
A motorcycle transmission is a transmission created specifically for motorcycle applications. They may also be found in use on other light vehicles such as motor tricycles and quadbikes , go-karts , offroad buggies, auto rickshaws , mowers, and other utility vehicles, microcars , and even some superlight racing cars.
Inside of a 231 New Process Gear transfer case. Part-time/Manual, shift on the fly. A transfer case is an intermediate gearbox that transfers power from the transmission of a motor vehicle to the driven axles of four-wheel-drive, all-wheel-drive, and other multi-axled on- and off-road machines.
Breakdown of VIIs under shear is a concern in motorcycle applications, where the transmission may share lubricating oil with the motor. For this reason, motorcycle-specific oil is sometimes recommended. [18] The necessity of higher-priced motorcycle-specific oil has also been challenged by at least one consumer organization. [19]
Simple two-stroke engines are lubricated by oil mixed into the fuel or injected into the induction stream as a spray. Early slow-speed stationary and marine engines were lubricated by gravity from small chambers similar to those used on steam engines at the time — with an engine tender refilling these as needed.
Commercial vehicle transmission diagram showing the gear fork, gearbox, and gears. Trained drivers of vehicles with non-synchronous transmissions sometimes use the techniques listed below. If improperly implemented, these techniques can cause damage to the vehicle or the loss of control of the vehicle.
For the wide-ratio transmission, the first gear ratio is 4:1 or 4, and in second gear it is 2:1 or 2, so the progression is equal to 4 / 2 = 2 (or 200%). For the close-ratio transmission, first gear has a 4:1 ratio or 4, and second gear has a ratio of 3:1 or 3, so the progression between gears is 4 / 3 , or 133%. Since 133% is ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Most often, the power is conveyed by a roller chain, known as the drive chain or transmission chain, [1] passing over a sprocket, with the teeth of the gear meshing with the holes in the links of the chain. The gear is turned, and this pulls the chain putting mechanical force into the system.