Search results
Results from the WOW.Com Content Network
Aqueous parts cleaning industrial washer. Parts cleaning is a step in various industrial processes, either as preparation for surface finishing or to safeguard delicate components. One such process, electroplating, is particularly sensitive to part cleanliness, as even thin layers of oil can hinder coating adhesion.
A chilled beam is a type of radiation/convection HVAC system designed to heat and cool large buildings through the use of water. [1] This method removes most of the zone sensible local heat gains and allows the flow rate of pre-conditioned air from the air handling unit to be reduced, lowering by 60% to 80% the ducted design airflow rate and the equipment capacity requirements.
An exploded-view drawing is a diagram, picture, schematic or technical drawing of an object, that shows the relationship or order of assembly of various parts. [1]It shows the components of an object slightly separated by distance, or suspended in surrounding space in the case of a three-dimensional exploded diagram.
In addition, CIP systems can be built into the borehole headworks to permit the injection of cleaning solutions (such as sodium hypochlorite or other sanitizers) and the subsequent recirculation of the mix of these chemicals and the groundwater. This process cleans the borehole interior and equipment without any invasive maintenance being required.
The average standard central vacuum system is equipped with a 30 foot (9 m) hose, plus standard cleaning tools similar to those used with portable vacuum cleaners. For further convenience, some owners will keep a hose and set of tools on each floor of a multi-story building.
Diagram of the different components that make up a standard high efficiency glandless circulating pump. The primary design factors of a high efficiency glandless circulating pump include an electronically commutated synchronous motor, a permanent magnet rotor, and canned rotor technology.
A beam is a structural element that primarily resists loads applied laterally across the beam's axis (an element designed to carry a load pushing parallel to its axis would be a strut or column). Its mode of deflection is primarily by bending , as loads produce reaction forces at the beam's support points and internal bending moments , shear ...
This observation is the basis of the I-beam cross-section; the neutral axis runs along the center of the web which can be relatively thin and most of the material can be concentrated in the flanges. The ideal beam is the one with the least cross-sectional area (and hence requiring the least material) needed to achieve a given section modulus.