Search results
Results from the WOW.Com Content Network
In this method the chemical equation is used to calculate the amount of one product which can be formed from each reactant in the amount present. The limiting reactant is the one which can form the smallest amount of the product considered. This method can be extended to any number of reactants more easily than the first method.
where A and B are reactants C is a product a, b, and c are stoichiometric coefficients,. the reaction rate is often found to have the form: = [] [] Here is the reaction rate constant that depends on temperature, and [A] and [B] are the molar concentrations of substances A and B in moles per unit volume of solution, assuming the reaction is taking place throughout the volume of the ...
Conversion and its related terms yield and selectivity are important terms in chemical reaction engineering.They are described as ratios of how much of a reactant has reacted (X — conversion, normally between zero and one), how much of a desired product was formed (Y — yield, normally also between zero and one) and how much desired product was formed in ratio to the undesired product(s) (S ...
As an example, consider the gas-phase reaction NO 2 + CO → NO + CO 2.If this reaction occurred in a single step, its reaction rate (r) would be proportional to the rate of collisions between NO 2 and CO molecules: r = k[NO 2][CO], where k is the reaction rate constant, and square brackets indicate a molar concentration.
One of the most important features introduced by Eyring, Polanyi and Evans was the notion that activated complexes are in quasi-equilibrium with the reactants. The rate is then directly proportional to the concentration of these complexes multiplied by the frequency (k B T/h) with which they are converted into products. Below, a non-rigorous ...
Stoichiometry is founded on the law of conservation of mass where the total mass of the reactants equals the total mass of the products, leading to the insight that the relations between quantities of reactants and products typically form a ratio of positive integers. This means that if the amounts of the separate reactants are known, then the ...
The conservation of mass principle dictates that the total mass of the reactants is the same as the total mass of the products. In the above example, the sum of molecular masses of A, B, C and D should be equal to that of R, X, Y and Z. As only R is the useful product, the atoms of X, Y and Z are said to be wasted as by-products.
From this table we see that the number of hydrogen and chlorine atoms on the product's side are twice the number of atoms on the reactant's side. Therefore, we add the coefficient "2" in front of the HCl on the products side, to get the equation to look like this: