Search results
Results from the WOW.Com Content Network
4 in × 1 in × 5.75 in (101.6 mm × 25.4 mm × 146 mm) = 376.77344 cm³. This smaller form factor is similar to that used in an HDD by Rodime in 1983, which was the same size as the "half height" 3½" FDD, i.e., 1.63 inches high. Today, the 1-inch high ("slimline" or "low-profile") version of this form factor is the most popular form used in ...
[citation needed] Some manufacturers measure figure height from the feet to the eyes rather than the top of the head; therefore, a figure that is 30mm to the top of its head could be considered to be a 28mm miniature. Figures of 15 mm, 20 mm, 25 mm, 28 mm, 30 mm, 32 mm, and 35 mm are the most common for role-playing and table-top games.
The M24 SWS has the "long action" bolt version of the Remington 700 receiver but is chambered for the 7.62×51mm NATO "short action" cartridge that has an overall length of 2.750 inches (69.85 mm). The "long action" allows the rifle to be re-configured for dimensionally larger cartridges up to 3.340 inches (84.84 mm) in overall length.
They were 3 + 1 ⁄ 4 inches (82.6 mm) high, 5 + 3 ⁄ 4 inches (146.1 mm) wide, and up to 8 inches (203.2 mm) deep, used mainly for hard disk drives and floppy disk drives. This is the size of the internal (screwed) part of the bay, as the front side is actually 5 + 7 ⁄ 8 inches (149.2 mm). The difference between those widths and the name of ...
This is a list of firearm cartridges that have bullets in the 9 millimeters (0.35 in) to 9.99 millimeters (0.393 in) caliber range. Case length refers to the round case length. OAL refers to the overall length of the loaded round. All measurements are given in millimeters, followed by the equivalent in inches between parentheses.
The 7.62×51mm CETME round is a variant of the 7.62×51mm NATO rifle cartridge with a plastic-cored lead bullet and a reduced propellant charge. The 7.62×51mm CETME is otherwise identical to the NATO standard.
Cooled by the aircraft's slip-stream, the air-cooled 12.7 mm AN/M2 was fitted with a substantially lighter 36-inch (91 cm) length barrel, reducing the weight of the complete unit to 61 pounds (28 kg), [82] [83] which also had the effect of increasing the rate of fire. The full official designation for this weapon was "Browning Machine Gun ...
The .277 Fury SAAMI (voluntary) MAP chamber pressure of 80,000 psi (551.6 MPa) enables a 135 grains (8.7 g) projectile muzzle velocity of 3,000 feet per second (914 m/s) from a 16-inch (406 mm) barrel. [1] [10] It also means that the .277 Fury is normally chambered in small arms that are capable of handling the accompanying bolt thrust safely.