Search results
Results from the WOW.Com Content Network
Data compression ratio, also known as compression power, is a measurement of the relative reduction in size of data representation produced by a data compression algorithm. It is typically expressed as the division of uncompressed size by compressed size.
Critical points of the elements (data page) — Critical point; Densities of the elements (data page) — Density (solid, liquid, gas) Elastic properties of the elements (data page) — Young's modulus, Poisson ratio, bulk modulus, shear modulus; Electrical resistivities of the elements (data page) — Electrical resistivity
Microsoft Excel 2010 running on Windows 7. Included in Office 2010, this is the next major version after v12.0, as version number 13 was skipped. Minor enhancements and 64-bit support, [114] including the following: Multi-threading recalculation (MTR) for commonly used functions; Improved pivot tables; More conditional formatting options
Monte Carlo method: Pouring out a box of coins on a table, and then computing the ratio of coins that land heads versus tails is a Monte Carlo method of determining the behavior of repeated coin tosses, but it is not a simulation.
The atomic ratio is a measure of the ratio of atoms of one kind (i) to another kind (j). A closely related concept is the atomic percent (or at.% ), which gives the percentage of one kind of atom relative to the total number of atoms. [ 1 ]
The tables below have been calculated using a heat capacity ratio, , equal to 1.4. The upstream Mach number, M 1 {\displaystyle M_{1}} , begins at 1 and ends at 5. Although the tables could be extended over any range of Mach numbers, stopping at Mach 5 is typical since assuming γ {\displaystyle \gamma } to be 1.4 over the entire Mach number ...
For each atom, the column marked 1 is the first ionization energy to ionize the neutral atom, the column marked 2 is the second ionization energy to remove a second electron from the +1 ion, the column marked 3 is the third ionization energy to remove a third electron from the +2 ion, and so on.
The following molar volumes and densities for the majority of the gaseous elements were calculated from the van der Waals equation of state, using the quoted values of the van der Waals constants. The source for the van der Waals constants and for the literature densities was: R. C. Weast (Ed.), Handbook of Chemistry and Physics (53rd Edn ...