Search results
Results from the WOW.Com Content Network
For instance, to safely fill a new container or a pressure vessel with flammable gases, the atmosphere of normal air (containing 20.9 volume percent of oxygen) in the vessel would first be flushed (purged) with nitrogen or another non-flammable inert gas, thereby reducing the oxygen concentration inside the container. When the oxygen ...
The system can be flushed with an inert gas to reduce the concentration of oxygen so that when the flammable gas is admitted, an ignitable mixture cannot form. In NFPA 56, [1] this is known as purge-into-service. In combustion engineering terms, the admission of inert gas dilutes the oxygen below the limiting oxygen concentration.
Explosive charges; Flow friction: Heat generated by high velocity oxygen flow over a non-metal Note:Flow friction is a hypothesis. Flow friction has not been experimentally verified and should be considered only in conjunction with validated ignition mechanisms. Friction between relatively moving parts; Fragments from bursting vessels
Usually atmospheric air supplies the oxygen for combustion, and limits assume the normal concentration of oxygen in air. Oxygen-enriched atmospheres enhance combustion, lowering the LFL and increasing the UFL, and vice versa; an atmosphere devoid of an oxidizer is neither flammable nor explosive for any fuel concentration (except for gases that ...
Consider the first triangular diagram below, which shows all possible mixtures of methane, oxygen and nitrogen. Air is a mixture of about 21 volume percent oxygen, and 79 volume percent inerts (nitrogen). Any mixture of methane and air will therefore lie on the straight line between pure methane and pure air – this is shown as the blue air-line.
The original mass of flammable material and the mass of the oxygen consumed (typically from the surrounding air) equals the mass of the flame products (ash, water, carbon dioxide, and other gases). Lavoisier used the experimental fact that some metals gained mass when they burned to support his ideas (because those chemical reactions capture ...
Division 2.1: Flammable, Non-Toxic Gas Flammable gas means any material that: Is ignitable at 101.3 kPA (14.7 psia) when in a mixture of 13 percent or less by volume with air; or; Has a flammable range at 101.3 kPa with air of at least 12 percent regardless of the lower limit.
The explosive properties of these mixtures were discovered in Germany in 1895 by Prof. Carl von Linde, a developer of a successful machine for liquefaction of gases, who named them oxyliquits. In 1930, over 3 million pounds (1.4 × 10 ^ 6 kg) of liquid oxygen were used for this purpose in Germany alone, and additional 201,466 lb (91,383 kg ...