Ads
related to: wood ceiling beams timbers and prices pictures of living walls imagestimberlyne.com has been visited by 10K+ users in the past month
surfacingsolution.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
In this type of construction, the vigas are the main structural members carrying the weight of the roof to the load-bearing exterior walls. The exposed beam-ends projecting from the outside of the wall are a defining characteristic of Pueblo architecture and of Spanish Colonial architecture in New Mexico, often replicated in modern Pueblo ...
Building a palisade wall for the fort at Jamestown, Virginia The Golden Plow Tavern in York, PA, is a very unusual American building. It is built with corner post construction on the ground floor, half-timbered style of timber framing on the upper floor and has a less common style of wood roof shingles than typical in America.
wall-plates (at the top of timber-framed walls that support the trusses and joists of the roof). When jettying, horizontal elements can include: The jetty bressummer (or breastsummer), where the main sill (horizontal piece) on which the projecting wall above rests, stretches across the whole width of the jetty wall. The bressummer is itself ...
A cruck or crook frame is a curved timber, one of a pair, which support the roof of a building, historically used in England and Wales. This type of timber framing consists of long, generally naturally curved, timber members that lean inwards and form the ridge of the roof. These posts are then generally secured by a horizontal beam which then ...
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
Timber roof truss example. The top members of a truss are known generically as the top chord, bottom members as the bottom chord, and the interior members as webs.In historic carpentry the top chords are often called rafters, and the bottom chord is often referred to as a tie beam.
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
The thickness of the ceiling-wall seldom exceeded 30 centimetres (12 in), excluding the beams. [ 17 ] In ancient Gaul , Spain , Portugal and Aquitaine , houses were constructed with peaked roofs daubed with lumps of dried mud and covered with reeds and leaves, while other roofs made with oak shingles or thatched. [ 18 ]
Ads
related to: wood ceiling beams timbers and prices pictures of living walls imagestimberlyne.com has been visited by 10K+ users in the past month
surfacingsolution.com has been visited by 10K+ users in the past month