Search results
Results from the WOW.Com Content Network
The routing configuration and usage of an aux-send will vary depending on the application. Two types of aux-sends commonly exist: pre-fader and post-fader. Pre-fader sends are not affected by the main fader for the channel, while post-fader sends are affected by the position of the main fader slider control for the channel.
Auxiliary sends can either be pre-fader or post-fader, in that the level of a pre-fader send is set by the auxiliary send control, whereas post-fade sends depend on the position of the channel fader as well. Auxiliary sends can send the signal to an external processor such as a reverb, with the return signal routed through another channel or ...
If a send mix is configured post-fader, then the level sent to the send mix follows changes to the main channel strip fader. [22] This is useful for reverberation and other signal processor effects. An example of this is when an engineer would like to add some delay to the vocals – the fader can thus be used to adjust the amount of delay ...
Until the 3.0 revision, very low data rates meant most A/V needed alternative connectors. USB-C can directly transport USB 3.1, DisplayPort, Thunderbolt, HDMI, and MHL protocols, with power, and audio and many other protocols are possible. Thunderbolt is the successor to FireWire, a generic high-speed data link with well-defined audio/video ...
USB-C plug USB-C (SuperSpeed USB 5Gbps) receptacle on a laptop. USB-C, or USB Type-C, is a 24-pin, reversible connector (not a protocol) that supersedes previous USB connectors and can carry audio, video, and other data, to connect to monitors, external drives, hubs/docking stations, mobile phones, and many more peripheral devices.
Depending on the design of the mixer, there may also be knobs for auxiliary sends, typically used for monitors and effects units. A pan knob can be used to send the signal to a specific side in a stereo system. A pre-fade listen (PFL) button allows the channel to be monitored. Depressing this button can display the level on a signal meter, and ...
Subgroups, auxiliary mixes, submixes or even the main outputs are routed through the matrix mixer to different loudspeaker zones, making the matrix essentially a "mix of mixes". [4] A front-of-house matrix may be used at a concert to switch between the headliner's and the opening act's mixing consoles. A matrix mixer feature may be included on ...
Graphics performance improvements, Zoning 2.0, automation curves, advanced metronome options, 64-bit mixing engine, more inserts with flexible pre/post fader, new look for Vintage Compressor, Tube Compressor and Magneto III, direct offline processing, HALion Sonic SE 3 featuring FLUX wavetable synth, automation range tool, Adapt to Zoom, new ...