Search results
Results from the WOW.Com Content Network
The half-H bridge type is commonly abbreviated to "Half-H" to distinguish it from full ("Full-H") H-bridges. Another common variation, adding a third 'leg' to the bridge, creates a three-phase inverter. The three-phase inverter is the core of any AC motor drive.
A Wheatstone bridge is an electrical circuit used to measure an unknown electrical resistance by balancing two legs of a bridge circuit, one leg of which includes the unknown component. The primary benefit of the circuit is its ability to provide extremely accurate measurements (in contrast with something like a simple voltage divider ). [ 1 ]
In power supply design, a bridge circuit or bridge rectifier is an arrangement of diodes or similar devices used to rectify an electric current, i.e. to convert it from an unknown or alternating polarity to a direct current of known polarity. In some motor controllers, an H-bridge is used to control the direction the motor turns.
ER = EPR is a conjecture in physics stating that two entangled particles (a so-called Einstein–Podolsky–Rosen or EPR pair) are connected by a wormhole (or Einstein–Rosen bridge) [1] [2] and is thought by some to be a basis for unifying general relativity and quantum mechanics into a theory of everything. [1]
A wormhole is a hypothetical structure which connects disparate points in spacetime.It may be visualized as a tunnel with two ends at separate points in spacetime (i.e., different locations, different points in time, or both).
A graph with 16 vertices and six bridges (highlighted in red) An undirected connected graph with no bridge edges. In graph theory, a bridge, isthmus, cut-edge, or cut arc is an edge of a graph whose deletion increases the graph's number of connected components. [1] Equivalently, an edge is a bridge if and only if it is not contained in any cycle.
The generation of a Rover Mitchell Movement involves some fairly complex number theory. If the number of full tables is a prime number greater than four, the roving pair can start anywhere and move either up or down two tables in each round, thus displacing and encountering a different North–South pair, a different East–West pair, and a ...
Charge pumps are used in H bridges in high-side drivers for gate-driving high-side n-channel power MOSFETs and IGBTs. When the centre of a half bridge goes low, the capacitor is charged through a diode, and this charge is used to later drive the gate of the high-side FET a few volts above the source voltage so as to switch it on.