Ad
related to: wire rope splicing instructions diagram printable version
Search results
Results from the WOW.Com Content Network
The product which is used to make an eye splice is known as: Oval Sleeve, Figure 8 Sleeve, Hourglass Sleeve, Duplex Sleeve, Ferrule and Nicos. Correct installation is critical to the performance of the product; this includes utilizing the correct tool groove and/or die, number of presses/bites, press sequence and gauging.
Ring splice – Attached the working end of a rope to a ring or clew. [6] Chain splice – Attached the working end of a rope to a chain. [7] Figure-eight "splice" knot – A splice-like bend knot used for joining two ropes. Horseshoe splice – A cut splice where the two sides of the loop are of unequal length.
The 1915 textbook Practical Electric Wiring describes the construction of the Western Union splice; short tie and long tie. The short tie splice has it being formed after stripping the insulation from a pair of wires for several inches, each, crossing the wires left over right as shown in figure part A; then, a hooked cross (figure part B) is formed holding the crossing point of the two wires ...
The eye splice is a method of creating a permanent loop (an "eye") in the end of a rope by means of rope splicing. The Flemish eye is a type of circular loop at the end of a thread. There are several techniques of creating the eye with its knot tied back to the line, rope or wire.
In addition to holding rope open to assist the creation of a rope splice, modern push fids have markings for precise measurements in a variety of sizes of rope. The length of these fids is typically 21 or 22 times the diameter of rope to be spliced. A one-half-inch (12.7 mm) diameter rope would have any accompanying fid 10.5–11 in (266.7 ...
Ropework or marlinespike seamanship are umbrella terms for a skillset spanning the use, maintenance, and repair of rope. Ropework is used by seafarers, climbers and military personnel. [1] Included are tying knots, splicing, making lashings, whippings, and proper use and storage of rope.
In stricter senses, the term wire rope refers to a diameter larger than 9.5 mm (3 ⁄ 8 in), with smaller gauges designated cable or cords. [1] Initially wrought iron wires were used, but today steel is the main material used for wire ropes. Historically, wire rope evolved from wrought iron chains, which had a record of mechanical failure.
Marlinspike derives from the practice of "marling", winding small diameter twine called marline around larger ropes to form protective whippings. [1] The long-billed fish marlin is thought to be named after the marlinspike. [2] Marlin spike gets its name from the small cord called marlin, which is typically tarred and used for the serving of rope.
Ad
related to: wire rope splicing instructions diagram printable version