Search results
Results from the WOW.Com Content Network
European Leafs are offered in the following trim lines: Visia, Acenta, N-Connecta, and Tekna. The N-Connecta adds from Acenta an intelligent around view monitor with moving object detection and front and rear parking sensors, part synthetic leather and cloth trim, heat pack with heated seats and heated steering wheel, 43 centimetre (17 inch ...
The Multimode Manual Transmission has the following gears: R, N, E, M+, M−. R: R is the reverse gear. It is similar to R in both traditional manual and in fully automatic cars. N: N is the neutral gear. It is similar to N in both traditional manual and full automatic. E: E is the functional equivalent of D in a full automatic.
For the 1999-2004 Jeep Grand Cherokees using the NV247 transfer case, in "4-All Time" mode torque is applied to only the rear wheels under normal driving conditions. A gerotor pump is connected between the front and rear output shafts and senses any speed difference between them. When the shafts are turning at different speeds (wheel slippage ...
The Japanese domestic market Dualis was offered in 2.0 G, 2.0 S, 2.0 G Four, and 2.0 S Four trim levels. All models are powered by 2.0-litre MR20DE engine matched to six-speed Xtronic CVT. The Dualis was discontinued in Japan on 31 March 2014, after which the Juke was the only Nissan's mini SUV still produced and sold in Japan until 2019.
In Generation 1 and Generation 2 HSDs, MG2 is directly connected to the ring gear, that is, a 1:1 ratio, and which offers no torque multiplication, whereas in Generation 3 HSDs, MG2 is connected to the ring gear through a 2.5:1 planetary gear set, [10] and which, consequently, offers a 2.5:1 torque multiplication, this being a primary benefit ...
The SR4 was a light-duty 4-speed manual that used ball and needle bearings on the countershaft with bronze synchronizer rings. The T4 improved this design with tapered roller bearings on the input and output shafts and a straight roller bearing on the counter gear. The T-5 is a T4 with an added overdrive gear. [2]
A hardware description language looks much like a programming language such as C or ALGOL; it is a textual description consisting of expressions, statements and control structures. One important difference between most programming languages and HDLs is that HDLs explicitly include the notion of time.
The only difference between DTC and DSC is the shape of the path along which the flux vector is controlled, the former path being quasi-circular whereas the latter is hexagonal such that the switching frequency of DTC is higher than DSC. DTC is accordingly aimed at low-to-mid power drives whereas DSC is usually used for higher power drives. [6 ...