Search results
Results from the WOW.Com Content Network
The product which is used to make an eye splice is known as: Oval Sleeve, Figure 8 Sleeve, Hourglass Sleeve, Duplex Sleeve, Ferrule and Nicos. Correct installation is critical to the performance of the product; this includes utilizing the correct tool groove and/or die, number of presses/bites, press sequence and gauging.
A marlinspike is used in working with wire rope, natural and synthetic lines, may be used to open shackles, and is made of metal. A fid is used to hold open knots and holes in canvas, and to separate the "lays" (or strands) of synthetic or natural rope for splicing. A variation of the fid, the gripfid, is used for ply-split braiding. The ...
The result is two figure-eight knots, each partly inside the other and tightening its hold on the other when they are pulled in opposite directions. This can be a permanent or temporary splice. While it precludes the ropes' slipping relative to each other, it is a typical knot in having less strength than the straight ropes.
Ring splice – Attached the working end of a rope to a ring or clew. [6] Chain splice – Attached the working end of a rope to a chain. [7] Figure-eight "splice" knot – A splice-like bend knot used for joining two ropes. Horseshoe splice – A cut splice where the two sides of the loop are of unequal length.
The eye splice is a method of creating a permanent loop (an "eye") in the end of a rope by means of rope splicing. The Flemish eye is a type of circular loop at the end of a thread. There are several techniques of creating the eye with its knot tied back to the line, rope or wire.
The 1915 textbook Practical Electric Wiring describes the construction of the Western Union splice; short tie and long tie. The short tie splice has it being formed after stripping the insulation from a pair of wires for several inches, each, crossing the wires left over right as shown in figure part A; then, a hooked cross (figure part B) is formed holding the crossing point of the two wires ...
Ropework or marlinespike seamanship are umbrella terms for a skillset spanning the use, maintenance, and repair of rope. Ropework is used by seafarers, climbers and military personnel. [1] Included are tying knots, splicing, making lashings, whippings, and proper use and storage of rope.
Splice site of a copper wire. Cable sleeve (lead sleeve) for connecting paper-insulated wires Insulating sleeves. The splicing of copper wires happens in the following steps: The cores are laid one above the other at the junction. The core insulation is removed. The wires are wrapped two to three times around each other .