Search results
Results from the WOW.Com Content Network
A motorized miter saw. A miter saw or mitre saw is a saw used to make accurate crosscuts and miters in a workpiece by positioning a mounted blade onto a board. A miter saw in its earliest form was composed of a back saw in a miter box, but in modern implementation consists of a powered circular saw that can be positioned at a variety of angles and lowered onto a board positioned against a ...
A splitter is a stationary blade of similar thickness to the rotating saw blade mounted behind it to prevent a board from pinching inward into the saw kerf and binding on the saw blade, potentially causing a dangerous kickback. [7] Like a riving knife, its thickness should be greater than the body of the saw blade but thinner than its kerf. [7]
An exploded-view drawing is a diagram, picture, schematic or technical drawing of an object, that shows the relationship or order of assembly of various parts. [1]It shows the components of an object slightly separated by distance, or suspended in surrounding space in the case of a three-dimensional exploded diagram.
The blade of a table saw cutting into wood. A table saw (also known as a sawbench or bench saw in England) is a woodworking tool, consisting of a circular saw blade, mounted on an arbor, that is driven by an electric motor (directly, by belt, by cable, or by gears).
A saw which combines the sliding and compound features is known as a sliding compound miter saw or SCMS. Before the advent of the radial arm saw, table saws and hand saws were most commonly used for crosscutting lumber. Table saws can easily rip stock, but it is awkward to push a long piece of stock widthwise through a table saw blade.
Miter squares are usually made from two fixed parts, a stock and a blade (sometimes called a tongue). The blade on a modern factory-made miter square is typically a thin piece of metal which is fixed at 45° onto or into the stock, forming a 'T' shape. The stock is usually much thicker than the blade and is made from wood, metal or plastic.
Flush-cutting backsaw (offset saw); handle can be turned to the other side. The work of a backsaw requires a thin, stiff blade. These two immediately incompatible requirements are resolved by swaging (and perhaps, spot welding) a stiffening cap over the length of the top edge of the blade.
A simple miter gauge. A miter gauge is a device used for holding workpieces at a set angle while being cut on table saws, band saws or sanded on stationary disk sanders.The miter gauge slides in a slot on the worktable (known as a miter slot) on the machine being used.