Ads
related to: wet multiplate clutch vs slipper gear drive oil
Search results
Results from the WOW.Com Content Network
This is an accepted version of this page This is the latest accepted revision, reviewed on 31 December 2024. Mechanical device that connects and disconnects two rotating shafts or other moving parts For other uses, see Clutch (disambiguation). Friction disk for a dry clutch A clutch is a mechanical device that allows an output shaft to be disconnected from a rotating input shaft. The clutch's ...
This type of clutch is designed to partially disengage or "slip" when the rear wheel tries to drive the engine faster than it would run under its own power. The engine braking forces in conventional clutches will normally be transmitted back along the drive chain causing the rear wheel to hop, chatter or lose traction. [3]
Twin Clutch SST (Sport-or Sportronic Shift Transmission) is the brand name of a six-speed dual-clutch automatic transmission, developed by Getrag for Mitsubishi Motors. [1] The system was first incorporated in the 2008 Lancer Evolution X , [ 2 ] [ 3 ] and was designed to be a more performance-oriented system than that developed by rival ...
The Hele-Shaw clutch was an early form of multi-plate wet clutch, in use around 1900. It was named after its inventor, Professor Henry Selby Hele-Shaw, who was noted for his work in viscosity and flows through small gaps between parallel plates. The clutch was innovative in not relying upon friction, as other clutches did.
In developing countries where typical motorcycles are 125–150 cc (7.6–9.2 cu in) displacement, the larger 249.5 cc (15.23 cu in) CBR250R is at the higher end of the sport bike range, [10] looking similar to much more powerful sporting machines with its full fairing in Honda's new layered style that was introduced on the 2008 CBR1000RR Fireblade and 2010 VFR1200F.
A dual-clutch transmission (DCT) (sometimes referred to as a twin-clutch transmission) is a type of multi-speed vehicle transmission system, that uses two separate clutches for odd and even gear sets. [1] The design is often similar to two separate manual transmissions with their respective clutches contained within one housing, and working as ...
Suzuki introduced an all-new GSX-R600. Underslung exhaust and slipper clutch introduced. Engine is completely new, but with the same bore and stroke as before. 2008–2010. New subframe, bodywork, and fuel tank. Introduction of new Suzuki Drive Mode Selector (S-DMS). 2011–present 2011 Suzuki GSX-R600
The VFR800 was the first non-JDM motorcycle to use VTEC valve-gear. Honda used VTEC to meet tightening noise and emissions standards and to increase the peak engine horsepower. Based on the VTEC-E system, the simplified motorcycle version of VTEC employs only two of the four valves per cylinder when operating at lower engine speeds.
Ads
related to: wet multiplate clutch vs slipper gear drive oil