enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   A 37° flare type end fitting for flexible hose. The AN thread (also A-N) is a particular type of fitting used to connect flexible hoses and rigid metal tubing that carry fluid. It is a US military-derived specification that dates back to World War II and stems from a joint standard agreed upon by the Army Air Corps and Navy, hence AN.

3. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   Threaded pipe and elbow.The pipe has a male NPT thread, while the elbow is female.. American National Standard Pipe Thread standards, often called national pipe thread standards for short, are United States national technical standards for screw threads used on threaded pipes and pipe fittings.

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Steel pipe is often joined with threaded connections; tapered threads are cut into the end of the pipe, and sealant is applied in the form of thread-sealing compound or thread seal tape (also known as PTFE or Teflon tape) and the pipe is screwed into a threaded fitting with a pipe wrench.

5. British Standard Pipe - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Pipe

   BSPP fitting. Two types of threads are distinguished: Parallel (straight) threads, British Standard Pipe Parallel thread (BSPP; originally also known as [1] British Standard Pipe Fitting thread/BSPF and British Standard Pipe Mechanical thread/BSPM), which have a constant diameter; denoted by the letter G.

6. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   JIC hydraulic fitting from 1967 Ford backhoe. It was badly stuck, but shows what a JIC fitting looks like. The left is the male part, the right is female. A JIC bulkhead adapter, which converts National Pipe Thread (NPT) on the left to JIC on the right. The angled seating surface is clearly visible on the far right.

7. North American Fire Hose Coupler Incompatibilities - Wikipedia

   en.wikipedia.org/wiki/North_American_Fire_Hose...

   [1] [25] 7.5 threads per inch were selected not just as a compromise between the 6, 7, and 8 threads per inch then in use, but because tools and methods had been developed to facilitate the conversion of existing 7 tpi and 8 tpi threads to 7.5 tpi threads, for couplings with an outside diameter ranging from 3 inches to 3 1/8 inches to the new ...