Search results
Results from the WOW.Com Content Network
Simple scheme of the apparatus for electro-oxidation process. The set-up for performing an electro-oxidation treatment consists of an electrochemical cell.An external electric potential difference (aka voltage) is applied to the electrodes, resulting in the formation of reactive species, namely hydroxyl radicals, in the proximity of the electrode surface. [11]
Electrolyte can be fed on both anode and cathode side or anode side only. [10] In the zero-gap design of AWE, the electrodes are separated only by a diaphragm which separates the gases. The diaphragm only allows water and hydroxide ions to pass through, but does not completely eliminate gas cross-over.
A noble diode pump is a type of ion pump used in high-vacuum applications that employs both a chemically reactive cathode, such as titanium, and an additional cathode composed of tantalum. The tantalum cathode serves as a high-inertia crystal lattice structure for the reflection and burial of neutrals, increasing pumping effectiveness of inert ...
Getter pump or sorption pump In laboratory vacuum systems, the bulk NEG getter is often held in a separate vessel with its own heater, attached to the vacuum system by a valve, so that it can be replaced or renewed when saturated. [8] Ion getter pump Uses a high voltage electrode to ionize the gas molecules and drive them into the getter surface.
An anodic protection system includes an external power supply connected to auxiliary cathodes and controlled by a feedback signal from one or more reference electrodes. [3] Careful design and control is required when using anodic protection for several reasons, including excessive current when passivation is lost or unstable, leading to ...
The design of a galvanic anode CP system should consider many factors, including the type of structure, the resistivity of the electrolyte (soil or water) it will operate in, the type of coating and the service life. The primary calculation is how much anode material will be required to protect the structure for the required time.
The terms anode and cathode are not defined by the voltage polarity of electrodes, but are usually defined by the direction of current through the electrode. An anode usually is the electrode of a device through which conventional current (positive charge) flows into the device from an external circuit, while a cathode usually is the electrode through which conventional current flows out of ...
The amount of electricity that has passed through the system can then be determined from the volume of gas. Thomas Edison used voltameters as electricity meters.. A Hofmann voltameter is often used as a demonstration of stoichiometric principles, as the two-to-one ratio of the volumes of hydrogen and oxygen gas produced by the apparatus illustrates the chemical formula of water, H 2 O.