Ad
related to: solenoid coil design theory pdf book
Search results
Results from the WOW.Com Content Network
A solenoid (/ ˈ s oʊ l ə n ɔɪ d / [1]) is a type of electromagnet formed by a helical coil of wire whose length is substantially greater than its diameter, [2] which generates a controlled magnetic field. The coil can produce a uniform magnetic field in a volume of space when an electric current is passed through it.
In engineering, a solenoid is a device that converts electrical energy to mechanical energy, using an electromagnet formed from a coil of wire. The device creates a magnetic field [ 1 ] from electric current , and uses the magnetic field to create linear motion.
This winding method reaches the highest fill factor and is the best way to fill the available winding cross-section with round wires. Square coils are seen as orthocyclically wound when the winding and layer jump occur only on one of the sides of the winding cross-section. In theory, a geometric fill factor of 0.91 will be reached.
A variable force solenoid (VFS) is an electro-hydraulic device that controls pressure proportionally or inversely proportionally to a signal (voltage or current) obtained from the on-board controller of a powertrain. A low flow VFS is used as a signal level devices for transmission line pressure control or application of clutches.
Here the energy is stored by disconnecting the coil from the larger system and then using electromagnetic induction from the magnet to induce a current in the superconducting coil. This coil then preserves the current until the coil is reconnected to the larger system, after which the coil partly or fully discharges. Refrigeration system
A common tractive electromagnet is a uniformly-wound solenoid and plunger. The solenoid is a coil of wire, and the plunger is made of a material such as soft iron. Applying a current to the solenoid applies a force to the plunger and may make it move. The plunger stops moving when the forces upon it are balanced.
A coil with a core which is a straight bar or other non-loop shape is called an open-core coil. This has lower magnetic field and inductance than a closed core, but is often used to prevent magnetic saturation of the core. A coil without a ferromagnetic core is called an air-core coil. [14]
Non-magnetic core tubes are used to isolate the fluid from the coil. The core tube encloses the plugnut, the core spring, and the core. The coil slips over the core tube; a retaining clip engages the depression near the closed end of the core tube and holds the coil on the core tube. Solenoid valve designs have many variations and challenges.
Ad
related to: solenoid coil design theory pdf book