Search results
Results from the WOW.Com Content Network
In the above formula, "36" is the conversion factor between yards and inches. Conversely, the group size of 1 arcminute at 100 yards (the most commonly used sighting-in distance in North America ) can also be calculated:
If one looks at red numbers on the chart specifying grade, one can see the quirkiness of using the grade to specify slope; the numbers go from 0 for flat, to 100% at 45 degrees, to infinity as it approaches vertical. Slope may still be expressed when the horizontal run is not known: the rise can be divided by the hypotenuse (the slope length).
The quarter of a yard (9 inches) was known as the "quarter" without further qualification, while the sixteenth of a yard (2.25 inches) was called a nail. [62] The eighth of a yard (4.5 inches) was sometimes called a finger, [63] but was more commonly referred to simply as an eighth of a yard, while the half-yard (18 inches) was called "half a ...
The Compositio redefined the yard, foot, inch, and barleycorn to 10 ⁄ 11 of their previous value. [dubious – discuss] However, it retained the Anglo-Saxon rod of 15 x 11 ⁄ 10 feet (5.03 metres) and the acre of 4 × 40 square rods. Thus, the rod went from 5 old yards to 5 + 1 ⁄ 2 new yards, or 15 old feet to 16 + 1 ⁄ 2 new feet. The ...
A Canadian football field is 65 yards (59 m) wide and 110 yards (100 m) long with end zones adding a combined 40 yards (37 m) to the length, making it 87,750 square feet (8,152 m 2) or 0.8215 ha (2.030 acres).
In astronomy, it is typically difficult to directly measure the distance to an object, yet the object may have a known physical size (perhaps it is similar to a closer object with known distance) and a measurable angular diameter. In that case, the angular diameter formula can be inverted to yield the angular diameter distance to distant objects as
Pace [6] in minutes per kilometre or mile vs. slope angle resulting from Naismith's rule [7] for basal speeds of 5 and 4 km / h. [n 1]The original Naismith's rule from 1892 says that one should allow one hour per three miles on the map and an additional hour per 2000 feet of ascent.
Similarly, an inch-pound (or pound-inch) is the torque of one pound of force applied to one inch of distance from the pivot, and is equal to 1 ⁄ 12 lbf⋅ft (0.1129848 N⋅m). It is commonly used on torque wrenches and torque screwdrivers for setting specific fastener tension.