Search results
Results from the WOW.Com Content Network
Unlike ATEX which uses numbers to define the safety "Category" of equipment (namely 1, 2, and 3), the IEC continued to utilise the method used for defining the safe levels of intrinsic safety namely "a" for zone 0, "b" for zone 1 and "c" for zone 2 and apply this Equipment Level of Protection to all equipment for use in hazardous areas since ...
Maximum experimental safe gap (MESG) is a standardized measurement of how easily a gas flame will pass through a narrow gap bordered by heat-absorbing metal. MESG is used to classify flammable gases for the design and/or selection of electrical equipment in hazardous areas , and flame arrestor devices. [ 1 ]
Intrinsic safety (IS) is a protection technique for safe operation of electrical equipment in hazardous areas by limiting the energy, electrical and thermal, available for ignition. In signal and control circuits that can operate with low currents and voltages, the intrinsic safety approach simplifies circuits and reduces installation cost over ...
OSHA Publication 3120, (Revised 2002). This booklet presents OSHA's general requirements for controlling hazardous energy during service or maintenance of machines or equipment. It is not intended to replace or to supplement OSHA standards regarding the control of hazardous energy. Health and Safety Executive, Electrical safety and you, a brief ...
Electrical shocks on humans can lead to permanent disabilities or death. Size, frequency and duration of the electrical current affect the damage. [8] The effects from electric shock can be: stopping the heart beating properly, preventing the person from breathing, causing muscle spasms. The skin features also affect the consequences of ...
This can include personnel wearing arc flash personal protective equipment (PPE) or modifying the design and configuration of electrical equipment. The best way to remove the hazards of an arc flash is to de-energize electrical equipment when interacting with it, however de-energizing electrical equipment is in and of itself an arc flash hazard.
Any leak which, in the judgment of operating personnel at the scene, is regarded as an immediate hazard. Escaping gas that has ignited. Any indication of gas which has migrated into or under a building, or into a foreign sub-structure. Any reading at the outside wall of a building, or where gas would likely migrate to an outside wall of a building.
In functional safety a safety instrumented system (SIS) is an engineered set of hardware and software controls which provides a protection layer that shuts down a chemical, nuclear, electrical, or mechanical system, or part of it, if a hazardous condition is detected.