Search results
Results from the WOW.Com Content Network
Status information and statistics of the connection through the internet gateway is not available as could be viewed in Windows XP. NAT port mappings can be set up from the gateway device's Properties-> Settings in Network Explorer. The Network Setup Wizard and the Wireless Network Setup Wizard have been removed.
Packets with this destination address may not be sent over any network link, but must remain within the current node; this is the multicast equivalent of the unicast loopback address. ffx2::/16: 224.0.0.0/24: Link-local Packets with this destination address may not be routed anywhere. ffx3::/16: 239.255.0.0/16: Realm-Local scope [28]
The default gateway can be specified by the route command to configure the node's routing table and default route. In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices.
Network address translation between a private network and the Internet. Network address translation (NAT) is a method of mapping an IP address space into another by modifying network address information in the IP header of packets while they are in transit across a traffic routing device. [1]
A special case of private link-local addresses is the loopback interface. These addresses are private and link-local by definition since packets never leave the host device. IPv4 reserves the entire class A address block 127.0.0.0 / 8 for use as private loopback addresses. IPv6 reserves the single address ::1.
Open Shortest Path First (OSPF) is a routing protocol for Internet Protocol (IP) networks. It uses a link state routing (LSR) algorithm and falls into the group of interior gateway protocols (IGPs), operating within a single autonomous system (AS).
Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private network Used for local communications within a private network [3] 192.0.0.0/24 192.0.0.0–192.0.0.255 256
Remote administration is performed by using the Windows Home Server Console client software provided in the bundle. Remote Desktop Services [19] connections to the server are supported while connected to the same LAN. [20] Remote access gateway: Allows remote access to any connected PC on the network, including the server itself, over the ...