enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. DC connector - Wikipedia

   en.wikipedia.org/wiki/DC_connector

   Two pin sizes are standard in the jacks for this size plug body, 2.1 mm (0.083 in) and 2.5 mm (0.098 in), and the plugs should match. If the size is not known, it is difficult to distinguish by eye or measurement between the 2.1mm and 2.5mm ID plugs; some suppliers suggest simple methods.

3. List of electronic component packaging types - Wikipedia

   en.wikipedia.org/wiki/List_of_electronic...

   For example, a metric 2520 component is 2.5 mm by 2.0 mm which corresponds roughly to 0.10 inches by 0.08 inches (hence, imperial size is 1008). Exceptions occur for imperial in the two smallest rectangular passive sizes. The metric codes still represent the dimensions in mm, even though the imperial size codes are no longer aligned.

4. Orders of magnitude (length) - Wikipedia

   en.wikipedia.org/wiki/Orders_of_magnitude_(length)

   The millimetre (SI symbol: mm) is a unit of length in the metric system equal to 10 −3 metres (⁠ 1 / 1 000 ⁠ m = 0.001 m). To help compare different orders of magnitude , this section lists lengths between 10 −3 m and 10 −2 m (1 mm and 1 cm).

5. List of disk drive form factors - Wikipedia

   en.wikipedia.org/wiki/List_of_disk_drive_form...

   4 in × 1 in × 5.75 in (101.6 mm × 25.4 mm × 146 mm) = 376.77344 cm³. This smaller form factor is similar to that used in an HDD by Rodime in 1983, which was the same size as the "half height" 3½" FDD, i.e., 1.63 inches high. Today, the 1-inch high ("slimline" or "low-profile") version of this form factor is the most popular form used in ...

6. Phone connector (audio) - Wikipedia

   en.wikipedia.org/wiki/Phone_connector_(audio)

   The 2.5 mm or sub-miniature sizes were similarly popularized on small portable electronics. They often appeared next to a 3.5 mm microphone jack for a remote control on-off switch on early portable tape recorders; the microphone provided with such machines had the on-off switch and used a two-pronged connector with both the 3.5 and 2.5 mm plugs.

7. Technical drawing tool - Wikipedia

   en.wikipedia.org/wiki/Technical_drawing_tool

   Rulers come in two types according to the design of their edge. A ruler with a straight edge can be used with lead pencils and felt pens, whereas when a technical pen is used the edge must be grooved to prevent the spread of the ink. An architect's scale. A scale ruler is a scaled, three-edged ruler which has six different scales marked to its ...