Search results
Results from the WOW.Com Content Network
Plastic syringes can be constructed as either two-part or three-part designs. A three-part syringe contains a plastic plunger/ piston with a rubber tip to create a seal between the piston and the barrel, where a two-part syringe is manufactured to create a perfect fit between the plastic plunger and the barrel to create the seal without the ...
A hypodermic syringe has the ability to retain liquid and blood in it up to years after the last use and a great deal of caution should be taken to use a new syringe every time. The hypodermic needle also serves an important role in research environments where sterile conditions are required.
Safety needles [1] serve the same functions as safety syringes, but the protective mechanism is a part of the needle rather than the syringe. Legislation requiring safety syringes or equivalents has been introduced in many nations since needlestick injuries and re-use prevention became the focus of governments and safety bodies.
Injector pens remove some of the complications of syringes by allowing the pen to be "pushed" against the skin at a 90-degree angle (removing the need to inject at a proper angle as is the case with syringes), as well as by replacing a long, thin plunger of a syringe with a simple button which is depressed and held to inject the dose. [2]
A syringe being prepared for injection of medication. An injection (often and usually referred to as a "shot" in US English, a "jab" in UK English, or a "jag" in Scottish English and Scots) is the act of administering a liquid, especially a drug, into a person's body using a needle (usually a hypodermic needle) and a syringe. [1]
The insulin syringe was the first syringe that is considered low dead space. It was initially created with low dead space for accurate measuring and mixing of fast and slow acting insulin, which had the added benefit of wasting as little of the expensive drug as possible.
accelerate the syringe forward, puncturing the injection site; actuate the piston of the syringe, injecting the drug; deploy a shield to cover the needle; Some injectors are triggered by simply pushing the nose ring against the injection site. In these designs, the protective cap is the primary safety.
Like a ground glass stopcock, the two parts of a gas syringe should preferably not be interchanged with another gas syringe of the same volume, unless told otherwise by the distributor. [3] Gas syringes come in various sizes from 500 ml to 0.25 ml and tend to be accurate to between 0.01 and 1 ml, depending on the size of the syringe. [4]