Search results
Results from the WOW.Com Content Network
A double floor is a floor framed with joists supported by larger timbers.. In traditional timber framing there may be a single set of joists which carry both a floor and ceiling called a single floor (single joist floor, single framed floor) or two sets of joists, one carrying the floor and another carrying the ceiling called a double floor (double framed floor).
The LH- and DLH-Series have been designed for the purpose of extending the use of joists to spans and loads in excess of those covered by Open Web Steel Joists, K-Series. LH-Series Joists have been standardized in depths from 18 inches (460 mm) through 48 inches (1,200 mm), for spans through 96 feet (29,000 mm).
Open web trussed joists and rafters are often formed of 4 cm by 9 cm (two-by-four) wood members to provide support for floors, roofing systems and ceiling finishes. Platform framing was traditionally limited to four floors but some jurisdictions have modified their building codes to allow up to six floors with added fire protection. [32]
Solid “bridging” to stabilize floor joists. Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking (dwang, nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
As of 2005, approximately 50% of all wood light framed floors used I-joists. [2] [clarification needed] I-joists were designed to help eliminate typical problems that come with using solid lumber as joists. The advantage of I-joists is they are less likely to bow, crown, twist, cup, check, or split as would a piece of dimensional lumber. I ...
Floors in wood-frame homes are usually constructed with joists centered no more than 16 inches (41 centimeters) apart, according to most building codes. [citation needed] Heavy floors, such as those made of stone, require more closely spaced joists.
In dimensioned lumber construction, the rim joists are the same depth, thickness and material as the joists themselves; in engineered wood construction, the rim joists may be oriented strand board (OSB), plywood or an engineered wood material varying in thickness from 1 inch (25 mm) to as much as 1 + 3 ⁄ 4 inches (44 mm), though they are ...
Rather, bents are simply cross-sectional templates of structural members, i.e., rafters, joists, posts, pilings, etc., that repeat on parallel planes along the length of the structure. The term bent is not restricted to any particular material. Bents may be formed of wooden piles, timber framing, [2] steel framing, or even concrete. [3]