enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Combined cycle power plant - Wikipedia

    en.wikipedia.org/wiki/Combined_cycle_power_plant

    The Cheng cycle is a simplified form of combined cycle where the steam turbine is eliminated by injecting steam directly into the combustion turbine. This has been used since the mid 1970s and allows recovery of waste heat with less total complexity, but at the loss of the additional power and redundancy of a true combined cycle system.

  3. Cogeneration - Wikipedia

    en.wikipedia.org/wiki/Cogeneration

    Cogeneration or combined heat and power (CHP) is the use of a heat engine [1] or power station to generate electricity and useful heat at the same time. Cogeneration is a more efficient use of fuel or heat, because otherwise-wasted heat from electricity generation is put to some productive use.

  4. Combined gas and steam - Wikipedia

    en.wikipedia.org/wiki/Combined_gas_and_steam

    Large (land-based) electric powerplants built using this combined cycle can reach conversion efficiencies of over 60%. [1] If the turbines do not drive a propeller shaft directly and instead a turbo-electric transmission is used, the system is known as COGES (combined gas turbine-electric and steam).

  5. Heat recovery steam generator - Wikipedia

    en.wikipedia.org/wiki/Heat_recovery_steam_generator

    Emissions controls may also be located in the HRSG. Some may contain a selective catalytic reduction system to reduce nitrogen oxides (a large contributor to the formation of smog and acid rain) or a catalyst to remove carbon monoxide. The inclusion of an SCR dramatically affects the layout of the HRSG.

  6. Thermal power station - Wikipedia

    en.wikipedia.org/wiki/Thermal_power_station

    A simple cycle gas turbine achieves energy conversion efficiencies from 20 to 35%. [5] Typical coal-based power plants operating at steam pressures of 170 bar and 570 °C run at efficiency of 35 to 38%, [6] with state-of-the-art fossil fuel plants at 46% efficiency. [7] Combined-cycle systems can reach higher values.

  7. Load-following power plant - Wikipedia

    en.wikipedia.org/wiki/Load-following_power_plant

    Load-following power plants can be hydroelectric power plants, diesel and gas engine power plants, combined cycle gas turbine power plants and steam turbine power plants that run on natural gas or heavy fuel oil, although heavy fuel oil plants make up a very small portion of the energy mix. A relatively efficient model of gas turbine that runs ...

  8. Bavarian Utility Installs GE's J920 FleXtra Gas Engine ... - AOL

    www.aol.com/news/2013-04-10-bavarian-utility...

    The upgraded cogeneration facility (36.1 MWel and 43.8 MWth) now meets about 40 percent of the electricity needs and 20 percent of the heating requirements of Rosenheim, which has more than 61,000 ...

  9. Gas-fired power plant - Wikipedia

    en.wikipedia.org/wiki/Gas-fired_power_plant

    A cogeneration plant in Berlin Gas generates over 20% of world electricity Share of electricity production from gas. A gas-fired power plant, sometimes referred to as gas-fired power station, natural gas power plant, or methane gas power plant, is a thermal power station that burns natural gas to generate electricity.