enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The major diameter may be slightly different from the shank diameter, which is the diameter of the unthreaded part of the screw. The diameters are sometimes given approximately in fractions of an inch (e.g. the major diameter of a #6 screw is 0.1380 in, approximately 9 ⁄ 64 in = 0.140625 in.

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw

4. Width across flats - Wikipedia

   en.wikipedia.org/wiki/Width_across_flats

   A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

5. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   For example, “.750-10 UNC-2A” is male (A) with a nominal major diameter of 0.750 inches, 10 threads per inch, and a class-2 fit; “.500-20 UNF-1B” would be female (B) with a 0.500-inch nominal major diameter, 20 threads per inch, and a class-1 fit. An arrow points from this designation to the surface in question. [19]

6. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread.

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw).