Search results
Results from the WOW.Com Content Network
Delta-sigma (ΔΣ; or sigma-delta, ΣΔ) modulation is an oversampling method for encoding signals into low bit depth digital signals at a very high sample-frequency as part of the process of delta-sigma analog-to-digital converters (ADCs) and digital-to-analog converters (DACs).
A delta-sigma ADC (also known as a sigma-delta ADC) is based on a negative feedback loop with an analog filter and low resolution (often 1 bit) but high sampling rate ADC and DAC. The feedback loop continuously corrects accumulated quantization errors and performs noise shaping : quantization noise is reduced in the low frequencies of interest ...
In delta modulation, the transmitted data are reduced to a 1-bit data stream representing either up (↗) or down (↘). Its main features are: The analog signal is approximated with a series of segments. Each segment of the approximated signal is compared to the preceding bits and the successive bits are determined by this comparison.
Sinc N filters are commonly used with delta-sigma modulation ADCs just prior to downsampling to the desired output data rate (ODR) of . A sinc N filter's frequency response will lie under a –20·N dB per decade envelope, so higher orders have steeper roll off for cutting out more high frequency noise, but will also have a lower -3 dB frequency .
Digital-to-analog conversion can degrade a signal, so a DAC should be specified that has insignificant errors in terms of the application. DACs are commonly used in music players to convert digital data streams into analog audio signals. They are also used in televisions and mobile phones to convert digital video data into analog video signals ...
This results in a broadband dynamic range of only 7.78 dB, but it is not consistent among frequency bands, and in the lowest frequencies (the audible range) the dynamic range is much greater — over 100 dB. Noise shaping is inherently built into the delta-sigma modulators. The 1-bit converter is the basis of the DSD format by Sony.
Counter type ADC: The D to A converter can be easily turned around to provide the inverse function A to D conversion. The principle is to adjust the DAC's input code until the DAC's output comes within ± 1 ⁄ 2 LSB to the analog input which is to be converted to binary digital form. Servo tracking ADC: It is an improved version of a counting ...
A 1-bit DAC (sometimes called Bitstream converter by Philips) is a consumer electronics marketing term describing an oversampling digital-to-analog converter (DAC) that uses a digital noise shaping delta-sigma modulator operating at many multiples of the sampling frequency that outputs to an actual 1-bit DAC (which could be fully differential to minimize crosstalk). [1]