Search results
Results from the WOW.Com Content Network
If the tire is not checked, it has the potential to cause vibration in the suspension of the vehicle on which it is mounted. In tire retail shops, tire/wheel assemblies are checked on a spin-balancer, which determines the amount and angle of unbalance. Balance weights are then fitted to the outer and inner flanges of the wheel. [2]
Some such pumps are designed to cut off before a suitable pressure (much higher for a bicycle than a car tire), and will much under inflate the tire. Others may not cut off, but deliver a high rate of flow to fill the larger car tire, with a risk of over inflating and bursting a bicycle tire unless it is stopped with split-second timing ...
The recommended inflation pressure is found in the owner's manual and on the vehicle's tire placard. [ 3 ] [ 4 ] Because of slow air leaks, changes in the weather and ambient temperature or other conditions, tire pressure will occasionally have to be corrected via the valve stem with compressed air which is often available at service stations.
Inflating a bicycle tire equipped with a Presta or Dunlop valve at an automobile filling station requires an adaptor, while a Schrader-valved tube does not. Inflating at home or on the road requires either 6mm air chuck for Presta and Dunlop valves, or an 8mm chuck for Schrader valves. An important advantage of Schrader valves relative to ...
Cold inflation pressure is the inflation pressure of tires as measured before a car is driven and the tires warmed up. Recommended cold inflation pressure is displayed in the owner's manual and on the Tire Information Placard attached to the vehicle door edge , pillar , glovebox door or fuel filler flap .
Colorized tire footprint pressure distribution. The contact patch is the portion of a vehicle's tire that is in actual contact with the road surface.It is commonly used in the discussion of pneumatic (i.e. pressurized) tires, where the term is used strictly to describe the portion of the tire's tread that touches the road surface.
An inflator stem is not used; instead, a removable cap on a valve stem embedded in the tire rim is fitted, with only the cap visible. When inflating the tire, the cap is first removed, typically with a coin, and then a "portable" dedicated inflator stem is screwed onto the valve stem. Through the inflator, the tire is inflated as usual.
Motor vehicles are normally equipped for changing a tire. These tools include a jack, a tire iron or lug wrench, and a spare tire. Air pumps run by hand-lever, pressure cans, or electricity can be used to re-inflate slow-leaking tires. One common way to temporarily repair and re-inflate a punctured tire at the roadside is to use a canned tire ...