Ad
related to: best non kinking oxygen tubing fittings for gas tanks
Search results
Results from the WOW.Com Content Network
A DIN standard for gas cylinder valves for test pressures up to 300 bar (4,400 psi). EN 15202 [9] A European standard for LPG equipment and accessories, specifying LPG cylinder valve connections. [10] EN 417: European norm specification concerning non-refillable metallic cartridges for liquefied petroleum gases.
In an oxygen system the presence of oxygen is implied, and in a sufficiently high partial pressure of oxygen, most materials can be considered fuel. Potential ignition sources are present in almost all oxygen systems, but fire hazards can be mitigated by controlling the risk factors associated with the oxygen, fuel, or heat, which can limit the ...
The pin index safety system uses a face seal between the cylinder valve and the associated yoke clamp. There are two holes in specific positions on the cylinder valve body below the outlet port , in positions associated with the gas mixture, which prevent connection of the cylinder to a yoke or pressure regulator with a mis-matched set of pins.
These fittings or special-service variants may also be found in hydraulic applications and alternative compressed gas applications (Oxy-acetylene welding and cutting, fuel gases, NSF C-2 food-contact, etc.).
For hoses and piping, a quick connect fitting, also called a push fitting, is a coupling used to provide a fast, make-or-break connection of gas or liquid transfer lines. Operated by hand, quick connect fittings replace threaded or flanged connections, which require wrenches. When equipped with self-sealing valves, quick connect fittings will ...
Flared fittings are an alternative to solder-type joints that are mechanically separable and doesn’t require an open flame. Copper tube used for propane, liquefied petroleum gas, or natural gas may use flared brass fittings of single 45°-flare type, according to NFPA 54/ANSI. Z223.1 National Fuel Gas Code.
An oxygen tank is especially dangerous because the gas is stored at a pressure of 21 MPa (3,000 psi; 210 atm)) when full. If the tank falls over and damages the valve, the tank can be jettisoned by the compressed oxygen escaping the cylinder at high speed. Tanks in this state are capable of breaking through a brick wall. [19]
A push-in compression coupling and tee.. Push-to-pull, push-to-connect, push-in, push-fit, or instant fittings are a type of easily removed compression fitting or quick connect fitting that allows an air (or water) line to be attached, nominally without the use of tools (a tool is still usually required for cutting tubing to length and removal).
Ad
related to: best non kinking oxygen tubing fittings for gas tanks