Ads
related to: anchor flange dimensions standard size pictures
Search results
Results from the WOW.Com Content Network
The ASME B16 Standardization of Valves Flanges, Fittings and Gaskets Committee, which operates under ASME’s Board on Pressure Technology Codes and Standards is responsible for standards covering valves, flanges, pipe fittings, gaskets and valve actuators for use in pressure services.
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
Standard sizes are indicated by the nominal inner diameter in millimeters for flanges 10 through 50 mm in diameter. [2] Sizes 10, 20 and 32 are less common sizes (see Renard numbers ). Some sizes share their flange dimensions with their respective larger neighbor and use the same clamp size.
Common sizes are from 9 ⁄ 16 to 10 ⁄ 16 inch (14 to 16 mm) square and 5 + 1 ⁄ 2 to 6 inches (140 to 150 mm) long. [10]: 582–583 A rail spike is roughly chisel-shaped and with a flat edged point; the spike is driven with the edge perpendicular to the grain, which gives greater resistance to loosening. [11]
Although flange fittings are bulky, they perform well in demanding applications such as large water supply networks and hydroelectric systems. Flanges are rated at 150, 300, 400, 600, 900, 1500, and 2500 psi; or 10, 15, 25, 40, 64, 100, and 150 bars of pressure. Various types of flanges are available, depending on construction.
A flange is a protruded ridge, lip or rim, either external or internal, that serves to increase strength (as the flange of a steel beam such as an I-beam or a T-beam); for easy attachment/transfer of contact force with another object (as the flange on the end of a pipe, steam cylinder, etc., or on the lens mount of a camera); or for stabilizing and guiding the movements of a machine or its ...
A UG-1666/U (MIL-standard) choke flange (left), and matching gasket/cover flange (right). These flanges are aluminium and are socket-mounted onto aluminium WG18 (WR62) waveguide. Electric current flows on the inside surface of the waveguides, and must cross the join between them if microwave power is to pass through the connection without ...
AN sizes range from -2 (dash two) to -32 in irregular steps, with each step equating to the OD (outside diameter) of the tubing in 1 ⁄ 16-inch increments. Therefore, a -8 AN size would be equal to 1 ⁄ 2-inch OD tube. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness.
Ads
related to: anchor flange dimensions standard size pictures