Search results
Results from the WOW.Com Content Network
Creating a subnet by dividing the host identifier. A subnetwork, or subnet, is a logical subdivision of an IP network. [1]: 1, 16 The practice of dividing a network into two or more networks is called subnetting. Computers that belong to the same subnet are addressed with an identical group of its most-significant bits of their IP addresses.
CIDR is based on variable-length subnet masking (VLSM), in which network prefixes have variable length (as opposed to the fixed-length prefixing of the previous classful network design). The main benefit of this is that it grants finer control of the sizes of subnets allocated to organizations, hence slowing the exhaustion of IPv4 addresses ...
A wildcard mask can be thought of as an inverted subnet mask. For example, a subnet mask of 255.255.255.0 (11111111.11111111.11111111.00000000 2) inverts to a wildcard mask of 0.0.0.255 (00000000.00000000.00000000.11111111 2). A wild card mask is a matching rule. [2] The rule for a wildcard mask is: 0 means that the equivalent bit must match
If there are multiple routes with the same subnet mask, the route with the lowest metric is used. If there are multiple default routes, the metric is also used to determine which to use. If there are multiple routes with the same subnet mask and metric, the system may use equal-cost multi-path routing as a forwarding strategy.
The term subnet mask is only used within IPv4. Both IP versions however use the CIDR concept and notation. In this, the IP address is followed by a slash and the number (in decimal) of bits used for the network part, also called the routing prefix. For example, an IPv4 address and its subnet mask may be 192.0.2.1 and 255.255.255.0, respectively.
For example, in a network with multiple subnets where nodes A and B are located in one subnet and nodes C and D are in another, a partition occurs if the network switch device between the two subnets fails. In that case nodes A and B can no longer communicate with nodes C and D, but all nodes A-D work the same as before.
Carrier-sense multiple access with collision avoidance (CSMA/CA) in computer networking, is a network multiple access method in which carrier sensing is used, but nodes attempt to avoid collisions by beginning transmission only after the channel is sensed to be "idle". [1] [2] When they do transmit, nodes transmit their packet data in its entirety.
This method of using the all-ones address was first proposed by R. Gurwitz and R. Hinden in 1982. [2] The later introduction of subnets and Classless Inter-Domain Routing changed this slightly, so that the all-ones value becomes the local broadcast address and the all-ones host address of each subnet is that subnet's directed broadcast address. [3]