Search results
Results from the WOW.Com Content Network
The Dallara SF19 is an open-wheel single-seater chassis produced by Dallara for use in the Japanese Super Formula championship. It debuted in 2019 , replacing the Dallara SF14 chassis. Throughout its production, it was the sole chassis used in Super Formula, however an engine development war between Honda and Toyota can lead to significant ...
The 2019 Japanese Super Formula Championship was the forty-seventh season of premier Japanese open-wheel motor racing, and the seventh under the moniker of Super Formula. The season began on 21 April at Suzuka Circuit and ended on 27 October at the same location.
Changed regulations both in Super Formula and Formula 1 resulted in closest gap ever between lap times: in 2014 season in Round 1 at Suzuka Circuit in Q2 André Lotterer did 1:36.996 which was 4.49 seconds slower than Nico Rosberg's pole time of 1:32.506 for the 2014 Japanese Grand Prix and was not only inside 107% rule but could potentially ...
The ailerons, bellies and bottom are modified. [3] Like the SF19, it is equipped with engines supplied by Honda or Toyota. [1] For some components of the bodywork, materials derived from flax fiber, cork and recycled carbon fiber are used. [2] This allows for a 75% reduction in carbon dioxide emissions in the production process. [3]
Although the concept of U-value (or U-factor) is universal, U-values can be expressed in different units. In most countries, U-value is expressed in SI units, as watts per square metre-kelvin: W/(m 2 ⋅K) In the United States, U-value is expressed as British thermal units (Btu) per hour-square feet-degrees Fahrenheit: Btu/(h⋅ft 2 ⋅°F)
A universal joint. A universal joint (also called a universal coupling or U-joint) is a joint or coupling connecting rigid shafts whose axes are inclined to each other. It is commonly used in shafts that transmit rotary motion.
The ratios between the slip angles of the front and rear axles (a function of the slip angles of the front and rear tires respectively) will determine the vehicle's behavior in a given turn. If the ratio of front to rear slip angles is greater than 1:1, the vehicle will tend to understeer, while a ratio of less than 1:1 will produce oversteer. [2]
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.